Denso IGN WIRE SET-5MM - 671-6182

Worked great

This set replaced perfectly the original equipment wires on my 1996 4Runner (I had purchased the last set from Toyota about 7 years ago). These wires are the same quality but less than half the price. The spiral insulating wrap is not present on these but it's easy enough to swap from the original wires. The number 3 wire on my OE set had two extra rubber insulators that were not present on this set, but they are probably not necessary.These wires are not numbered (as the OE set are) but the lengths are correct so it's easy enough to match them up to the correct coils and spark plugs. Incidentally, the numbers on the OE wires correspond to the coils on the passenger side, not the cylinders on the driver's side.The wire set includes installation instructions and a packet of silicone grease to lubricate the spark plug boots so be sure to use it. Just remove and install one wire at a time and you should have no problems installing these. It took me about an hour to install these but I'm slow. I got 100,000 miles out of my last set of OE wires and spark plugs and my 4Runner was still running great but it was time to replace them.

Great wire set. The real deal.

I had used NGK cables previously and these cables are better. The connection where it plugs into the ignition coil it does a much better job of sealing out moisture. It has a couple of bigger ridges on the plug to produce a much snugger fit onto the coil. I actually had some moisture get past the connection on the other cables and caused corrosion in the ignition coil at the connection. Enough of a problem to cause the engine to miss on one cylinder.

Wires seem to be of excellent quality and value for the money.Would recommend to anyone.

Worked with no issues.

It's Denso. No need to expand on it.

Work great!