AZUTO for Jeep Wrangler JL Front Seat LED Light Map Light Interior Front Light for Jeep Wrangler JL/Gladiator (JT) 2018-2025 MHG-043

Fits like a glove.

Not sure how I lived without this overhead light… No more fumbling for the button to turn on the factory overhead lighting… Not to mention, with the factory installed lighting, the passenger has to depend on you if to turn it on. If you are still pondering, watch the video included with this listing. The guy shows you how easy it is , start to finish. NOTE: I had also just ordered silver trim pieces for the Factory overhead light and it just so happened to include the silver trim that you see in this photo, adding to the decoration of this already nice looking, light. All in all, it just makes things look more well, equipped, whether the light is on or not.

Poor adhesive makes it hard to stick up and forget about it. The light should be brighter, but it gets the job done.

This product relies on 3M sticky tape to install. I throughly cleaned the surface before installing. It fell off amount immediately. I tried holding it in place for 30 sec to a minute and still would not stay in place. This if definitely a no go. Will be returning

Excelente producto

Really high quality part much easier to install than I expected. Light fades to full on in about 2 sec same turning off fades from bright to full off in about 2 sec. A really nicely designed accessory.

This is a great product for something clearly missing in the Jeep Wrangler series but unfortunately it does not work with Sky One-Touch sun room as it covers the Sky Roof button. I might see if there are other mounting options, perhaps on the roll bar. The light isnt as bright as I would have expected but seems like it would be functional.

I read many reviews on this and the reviews are polarizing. IMO, the light is adequate. Nothing impressive about the amount of light it produces, but it does the job fine and you can read stuff with it. I would not be soldering leads on a PCB with this light setup.It sure fills the gap where the factory has left off.The overall build quality of the unit makes all the browny points. It looks OEM and blends well with the rest of interior.The 3M adhesive installation is both convevient but also a curse. You need to have a very clean surface to adhere the light to otherwise you may end up redoing the install with new 3M trim tape.For some reason, the center portion of the light assembly would not completely adhere that it will stay adhered but after a min or so, but I can hear the adhesive give away. Ends of the light assembly also have 3M tape applied to it so overall the light assembly is holding on fine. So the note you should be taking is, work from the center and move out to the side when applying the unit onto its final position.I would be concerned if I was in the South.Light turns on/off slowly/gradually. I wish the timing was a little quicker but still livable.I used the same camera setup to show light on and off. These photos are taken with no street lights around. You can see how much light it is producing.At 99 dollars, it is not cheap but with the quality and the solution that it provides, it is a worthwhile investment for me. I paid for this product.