Archer Plus SR10+ Receiver 3-Axis Gyro & Accelerometer 10 Configurable Channels Access & ACCST D16 Compatible Anti-RF Interference FBUS & S.Port Telemetry Black Box Data Logging

Great receiver, frsky is the best

lately, these receivers come with firmware 1.0.11 - good for Ethos stabilization tools version 3.0.0. if you run edgeTX or OpenTX, after registration or binding you will need to downgrade to version 1.0.10 or lower and find the correct stabilization scripts in EdgeTX Github. This could be a challenge if you are not savvy in scripting or software tools.

This is a rock solid receiver with Auto Level (SAFE), Normal Gyro Stabilization (like AS3X), and Off modes. Make sure you go through the two Lua scripts for setup and also calibration.

Does everything that you want.

I should be grateful that they support the older radios at all. I specifically wanted 10 channels, but the bottom to ports are fixed as SBUS and S.Port. There is no way to change them without an ACCESS transmitter. Also nice is a complete second set of gyro outputs that can be mixed/ configured separately. Also bad, you need an ACCESS transmitter to use them. Feels a lot like keeping new features behind a paywall.

I switched from Spektrum to Frsky over 2 years ago. Frsky cost 1/3 of Spektrum and offer more feature and functionalities.

I've always had good luck with the SR 10 series free Sky receivers

FrSky Archer plus products are advertised to support both ACCESS and ACCST protocols. This product does support both but if you use ACCST channel 9 and 10 are used for sbus, i.e. it's an 8-channel receiver. I verified this with the factory (same problem with their archer plus 12 channel, 8 channels only using ACCST. 16 channels are available on sbus.) More bad news. Out of the box, this SR10 plus would not bind to stock FrSky X9D+ 2019 running standard OTX and ACCESS. After reflashing the receiver to current FW version, it will register and bind but channel 9 and 10 are dead. Even though I am not operating the receiver in stability mode, if you want to use 9 and 10, you must configure receiver in stability mode using frsky LUA script, then enable 9 and 10, then turnoff stability. Haven't tried it for two reasons. I have SR8 plus and the current FrSky LUA scripts for SR8 plus, for OTX do not work, never worked. To configure the SR8 gyros with X9D+2019 you have to use a down revision of the LUA script.) The SR10 plus LUA is over a year old, not updated when FrSky updated the SR10 plus FW, so its not likely to work. Second, as delivered doesn't work with X9d+2019 using ACCESS, doesn't meet specification. Its a reminder that FrSky is only supporting Ethos based transmitters.