VViViD+ Gloss Metallic Chameleon Blue to Purple Color-Shift (1ft x 5ft) with Air Release

Used as a golf shaft wrap and it went on smoothly! If you're thinking of doing something similar, here's my process.Cut the vinyl to the proper size. for 45-47" driver, the butt end is 2" wide and the tip is 1.5". I measure the half way point at 1-3/4. Use a piece of painters tape wrapped around the shaft to ensure measurements will fit your shaft.If possible, roll the grip opening up over itself to access the shaft under the grip.Apply the shaft wrap at the butt end first; Centering the wrap with the upper side of the shaft. It doesnt matter that much as the wrap is nearly seamly when applied correctly. Press the wrap down the length of the shaft and back up. Work one side of the shaft till it is laid down smoothly around the back, then the other side in the same manner. Trim and excess from the tip end using a razor or sharp knife. Cut angle towards the ferrule and do not cut into your graphite shaft. If your shaft is steel, you have nothing to worry about on that front.Last thing, IMPORTANT! Make sure there arent any crinkles or bubbles BEFORE applying heat. I used a hair dryer set on high and went up and down the length of the shaft a few times, pressing the wrap firmly as I went around. When youre done, roll the grip back down.Wrap added 8gr to the shaft weight. Wrap does not affect playability or flex.

I used Vvivid Gloss Metallic Chameleon Purple color shift 1' x 5' for a 14 x 12 floor tom. The width was perfect at about 11 7/8" and I never trimmed the length which was about 9" over what was needed. I removed the crusty old wrap which was about 1mm thicker than the Vvivid wrap, lightly sanded the drum shell, vacuumed and wiped it down with a damp cloth. I had little trouble laying down the new wrap. If you're careful about lining it up correctly in the first few inches it goes down nicely with no bubbles as long as you take it slow.

Purchased this to wrap my Steamdeck instead of going through the painstaking task of a new shell. It was so easy and turned out perfect! Used my cricut to cut it out, and slowly used a heat gun to secure the fit. Will be buying more colors for other items around my house!

Got this to make some projects - the reviews that it is not the worst to weed but not the easiest is pretty accurate. It definitely helps to have a light above when you are weeding because the color shift makes it hard to see the lines. I'm trying to figure out the best setting on my cricut, the premium vinyl w/ extra pressure seems ok but wondering if there might be a better one. Also, that protective layer definitely threw me off when I cut it the first time. Welcome suggestions on setting for the Circut Maker if anyone has them.Edited: The Cricut Premium Holographic setting has been the most successful with a light pressure. Also, the rolling/tubing issue is very bad with this product. It's pretty enough that I'll work around it. I've also been hitting it with a heat gun for a seal to help it stay in place.

This is great stuff 3m ,great adhesive, color is on point 👉 👈. Using to wrap my downhill mtn bike frame

Great customer service and easy to install. Definitely use a heat gun though. A hairdryer won’t produce enough heat (that came directly from the manufacturer). Get some and try it out!

Very nice would buy from this company again they do a good job

Love it! I used it to wrap my Monster Ripper.