Windshield A-Pillar Molding Trim Compatible with 2011-2019 Ford Explorer Replaces 926-450,926-451,BB5Z7803137AA, BB5Z7803145AA, BB5Z7803136AA, BB5Z7803144AA(Left and Right 4 Pack Outer and Inner)

2016 Ford Explorer XLT 4wd. Like most of this year, my pillar rubber had completely rotted away and made an annoying noise when driving above 40mph. I looked around amazon and basically all replacement pillar trims had mixed reviews. I went with this one because the L/R Inside/Outside 4-pack was cheaper than alternatives. I will say the following:-The holes line up perfectly.-The (inner piece) trim seals to the window well.-The (outer piece) cover fit is "fair". But I can't deduct stars because I don't know if that's because of the manufacturing or because of my own technique. There's a little play in installing the inner piece, and in the 110 degree humid sun of Florida I didn't really want to sit there and mess with it. Plus, once you sit the outer piece onto the inner piece the adhesive tar makes a seal against the inner piece rubber and it's pretty sticky and messy.-The adhesive tar that comes pre-applied to the outer piece is messy. This is one area the product could improve, it's pretty liberally smeared on the piece and you'll need some goo-gone to clean it up because it squeezes out of the trim piece and needs to be cleaned up once the install is done.-The outer pieces are fragile, when you're pressing them down against the inner piece clips you should use caution. I got to "smacking" it down and cracked it, but it's my own fault, and the crack isn't super noticeable. Overall, considering the price difference between this part and the OEM Ford part, I would say it's worth the concessions listed above, and therefore I can't deduct any stars.

Wow what a difference! These are great quality pillars and very easy to install if you take your time. The 2 way tape is 1/2 inch and good quality. I took the strip off the tape first cause if you don't really hard to get it off because it seals tight. I started at the top and went downward it popped on easy! What a big difference from my old ones I got off ebay! Would highly recommend 👌 Thank you 😊

Won’t secure .. flew off right after installation by repair shop

Put these on a 2016 Explorer. The A pillar molding was rotten & falling off. The fit was perfect, but I would advise leaving the tape mostly on and gently pull it of after you have it all lined up especilly the top piece of plastic that fits into the hole at the top of the a pillar frame.

Great quality just delivered it 30 min ago it’s already installed

Perfect fit and easy to install, I give it 4 stars as the upper rubber comes with a really bad double sized tape that came off immediately and therefore I replaced it with 3M. Other than that very good product for pricing.

These are an affordable replacement since ford can't seem to provide replacement parts

Cheap Chinese product. The clips don’t line up correctly and when you install, it breaks.