LED Dimmer Switch, Trailing Edge Double Dimmer Light Switch for Dimmable LED/Halogen Lights, Rotary Push On/Off, 2 Gang 1 Way/2 Way, 3-150 Watts, White

This has replaced the old dimmer switches. Prior to changing to these the lights were flickering a lot. Bulbs were changed etc, then the thought was to change the switches- no more flickering now. They look fine.

Works a treat

I initially put a cheap EverReady dimmer switch in my office to control the main dimmable LED bulb that lights the room. The buzzing sound emitted from the light fitting was intolerably loud unless the light was on full. At the time I didn't know that you need a specific type of dimmer for dimmable LEDs. After some research I found that the best option was a trailing edge dimmer, and settled on this one specifically advertised as being compatible with low wattage LEDs.This switch has almost eliminated the buzzing entirely. It is still there but it is not really audible to me unless I sit in silence and really try to listen out for it. I am using a Philips B22 dimmable bulb, similar to model number 8719514323872 but rated for 7.5W 806lm (I think the bulb I have is discontinued now).The switch was very easy to install, and I am actually really happy with the faceplate. It is made from Bakelite (or something like it) rather than Nylon or whatever they're usually made of. It has a very nice subtly textured matte finish to it and a much nicer feel than the usual plastic switches. The two white plastic plugs that hide the screws are a nice touch too.I reluctantly knock 1 star off only because the buzzing is still present, albeit incredibly quiet. I suppose this could be to do with the wiring in my house, the light fitting or the bulb itself and it is so quite it's basically inaudible unless you try to hear it. Consider it a 4.5 star review.

Needed a new dimmer switch which would work with LED light bulbs. Not difficult to make elecrrical connections. Decided to fit a 10mm deep surface mounting pattress behind switch to avoid having to crush connecting wires excessively. Good product at a reasonable price.

I've been using LAP dimmers in my house for years and they've always made the lights flash. I assumed they mustn't be for LED bulbs but in changing them and looking closer they claimed to be just that. So it just shows flashing issues can be down to various factors including the dimmer. This one works flawlessly with a smooth dim and no hum or flashing like the LAP ones. Came missing the grub screws on the earth terminal, contacted the company who replied promply and instead of just sending the screws they sent a whole new dimmer switch. Impressed that they'd even put a card in the box with their contact details, you don't see that often, hence highly pleased all round.Both units I received the nut behind the button needed tightening, the button however pulls off so you can get a spanner in easily, you could probably even tighten it by hand tbh.

Installed this to dim my LED kitchen downlights.It works well.Please note you must have the special dimmable LED light bulb units, otherwise this will not work.

The switch/dimmer itself works fine, no complaints there. The face plate however is of very poor quality. It has 2 earthing connectors attached to the back, poorly soldered right next to where the fixing screws go. Since the whole face plate is metal, it doesn't matter which of the two you use. As I was screwing in the earthing wire to one of them, the solder broke off and it just came off the faceplate with barely any force applied. I thought that maybe it was just a one-off defect, so I tried the other one. Yet, the same thing happened again with the other one. In the end I had to solder one of them back to the faceplate myself and this time it didn't come off. Eventually, I had it all installed but then I realised that the faceplate got some very fine scratches just by handing and installing it, even though I had been extra careful not to scratch it. Very poor quality indeed.

Works but needs a deep housing. Easy to fit