SPDT 10Amp Power Relay Module, Plastic Enclosure and Pre-Wired (AC 120V)

Worked as described. Firing coil with neutral to open N/O contacts through a float switch in swamp cooler to shut water pump off if reservoir runs low. Filled conduit entry with silicone for unlikely event of splashing water. Wouldn’t really say it is rated for outdoor use but can’t remember if it said it was lol.

Nicely made. Does what it should. Mounting screws are not 6-32 so you need to buy screws to mount in steel boxes

Using as a garage door interface. Works awesome

I used this to wire up my garage lights to the opener and keep it isolated. It works very well for my purpose. I would give it five stars except I have found that occasionally it sticks and when the switch power shuts off, the solenoid gets stuck on. The old power cycle resets it, but it's still a bit annoying.

Product was defective and did not work.

Works perfectly for what I needed.

Works perfectly, but it will try to rotate on you if you don't sinch up the lock nut real tight (when putting directly on an electrical box with a punch-out). The coil is completely separate from the contacts, so you can isolate circuits. The color scheme is a little odd for the contacts but it is written on the outside of the unit.

Works as described! Nice enclosure that mounts into a 1/2" knockout!

Great product so far. Installed and running for a few weeks now. Will order a spare just incase it fails down the road, but so far so good. Documentation is accurate.