498298 Carburetor for Briggs & Stratton 495426 495951 492611 490533 692784 5 HP Carb 135202 130202 137202 135212 133202 134202 133212 112202 112231 112232 Carburetor with 491588S Air Filter

Great price for a replacement carburetor. Easy to install and worked perfectly on the first startup. Absolutely no adjustment needed. You will need to borrow a few parts off of your original carburetor but it’s not a problem. My old 1982 pressure washer purrs like a kitten.

I bought this for my 35 year old roto tiller that gets used twice a year.The old carb and fuel tank were all full of nasty old gas and corrosion from years of ethanol rich pump gas. The new carb installed with out too much trouble,unlike others have stated all the screw holes were the right size and the gaskets were correct.I'm glad I took pictures of the linkages before disassembly.that hepled me on reassembly otherwise some of it was a mystery. Started right up and ran well.Didnt need much choke either.I should have done this years ago.

It was a direct fit on the 5 hp Briggs & Stratton engine. I did have issues with one threaded home, a little modification had to be done. Otherwise, this was a good carburetor.

Just what I needed to fix up an old 5hp Crsftsman chipper/shredder The carb is 99% the same. It has a choke spring that is way too stiff so I just cut it off since the original didn't use one anyway Also the threaded hole that mounts the throttle guide us smaller than the original, but I had some smaller hardware on hand. Also the tank to carb gasket holes are just slightly off, not so bad that you can't use it but figured Id mention it. Other than that, everything is great. Got everything put back together and it fired up first pull, no adjustment needed!

My fiancé installed this Carburetor built by Briggs & Stratton and didn’t have any significant issues during installation with the parts. Our weed eater is up and running.

I purchased this 498298 carburetor kit for my Briggs & Stratton engine on a wood splitter, and it worked out perfectly. The carburetor was an exact fit, which made installation straightforward with no modifications needed. What really made this a great purchase is that it came as a complete kit. The included air filter, spark plug, and gaskets meant I had everything needed to finish the job in one go, which saved time and extra trips for parts. After installation, the engine runs smoothly again and starts up without issue. Overall, this was a very convenient and cost-effective repair solution. I’d definitely recommend it for similar small engine repairs.

It fit my 90s craftsman tiller motor, however : some of the holes are not tapped for the parts you have to transfer over and one hole was tapped the wrong size. I had to create bottom taps to correct these problems.

Fit and Work great. No issues with it.