Queekay50 Pcs Honeycomb Pins for Laser Cutting 7.5-8 mm Laser Honeycomb Bed Hold Down Pin Machine Fixing Needle Working Table Cutter and Engraver Machine Accessories(Black)

Works as it should. no problems.

These pins are a must have for your honeycomb beds. They're easy to install and fit like a glove.

I started out using magnets to hold down my work. However, I always had problems with the magnets getting in the way. These work great because they hold well with even a small amount covering the side of the piece. I really like them and the price was good. I would get them again.

I purchased these to use with my two tree laser honeycomb and they work great. They are just a little larger than the ones that came with the printer but it works out well because they fit snugger and hold better.

Fasten the top and grips in the honeycomb base.

The pieces are so easy to use both putting in and taking out. The amount I received was awesome

These are not laser bed support plugs they are auto body clip plugs and they don’t fit they are super loose waste of money.

Basically your average auto retaining pins for securing plastic auto trim, wheel well liners etc. The pin part of the fastener needed to be a little thicker to secure properly in the honeycomb laser work table. I just wrapped a little tape around the peg part of the fastener to secure them in the honeycomb holes. Now tey work fine and I am not going to fuss about it.

They took a while to arrive but that wasn't an issue for me as there was no great rush. I found they were too thin for my honeycombe bed for my diode laser engraver and they wouldn't keep the materials to be engraved on the bed