🚗 Elevate Your Drive with KIKIMO!
The KIKIMO Phone Holder is a custom-designed accessory for Tesla Model 3 and Model Y, ensuring a seamless fit in your dashboard. With a 360° adjustable mount, it provides optimal viewing angles while maintaining a noise-free experience. Made from reinforced ABS material, it guarantees stability for phones up to 3.9 inches wide. Installation is a breeze with its snap-on design, and it comes with a one-year warranty for peace of mind.
| Product Dimensions | 6 x 12 x 7 cm; 100 g |
| Item model number | ZE-002 |
| Special features | Rotatable |
| Color | Black |
| Item Weight | 100 g |
K**R
The word tesla is not written
I bought this product and its not same as the pic
R**A
Helpful
Very good and helpful service with the seller
A**R
Excellent-no rattling, but too small for standard phone case
Excellent design and rubber mitigates rattling. Unfortunately, the second one I ordered was too small to fit my phone case. This particular one was left by accident in a Uber.
C**N
Tesla design
Very simple to use and looking good with the Model 3
B**Y
No use for right-hand-drive vehicle
We have a right-hand-drive Model Y but, as far as we can see, the bracket is designed for a left-hand-drive vehicle. We couldn't fit it. NOT adjustable or suitable for all cars as the advertisement says. Should NOT be sold in the UK. Bracket holds phone well. As other reviewers say, the car mount is pretty cheap plastic.
D**S
Best phone holder for Tesla model Y and 3
Test drive twice. My IPhone XR fits nicely. As recommended by few YouTubers I chose to set it up on the left side of the steering wheel (see the picture).Did FaceTime. No issues such as excessive vibration that could impact picture quality. If you have a rattling issue, pl check the installation. Mine came as three separate pieces in a no name generic box. No instructions either.Her are my installation steps.1. Install part C first on the air vent. Part C top has two rubberized “channels”. See which of the channel would give you the snuggest snd tightest fit. Then simply slide in the bottom part of the part C. If you got this right, you won’t experience any rattle.2. Loosen the back nut 🔩 and insert the round ball part. Then lightly tighten the nut. Don’t over tighten.3. Insert the back L shaped side of part B into the front of part C.4. Position part A at desired angle.5. Do a quarter twist on the part A back.You are done.
A**I
It's won't stay
I tried this item in my car, but it won’t stay and has been dropped.I tried it several times, but it’s not gonna work for me
Trustpilot
1 week ago
3 weeks ago