RDINSCOS Rechargeable Angle Meter Magnetic Angle Gauge

These worked perfectly, I used these to find the angles when building a roll cage fory daughters RZR.

Very nice. Works great, very useful. Magnets could be stronger.

Works great

Great product for my table saw to adjust the blade angle. More accurate cuts and professional results.

The laser is a bit weak. It works fine in the house or in a dimly lit environment, but is not bright enough for outside use during the day. The angle measuring capability of the device was acceptable.

It's hard to explain, but I love using this square. It's clever to have magnets (plenty strong) on four sides and it was perfect for what I needed. I wouldn't use it on an irregular surface, but other than that, it's been my go-to tool for horizontal & vertical objects. The laser is really helpful when you gave a mid or endpoint and need to scribe a line further away. Less cumbersome by far than a long level. I don't think it could replace all of your other levels, but you could use it instead the majority of the time. It's also great for setting up power tools with blades or bits. Oddly, I find it my most fun new tool to use and it wasn't expensive. Just cool.

I purchased this level for set up woodworking table saws, miter saws, etc, unfortunately the magnet is too week, or the plastic is to slippery - the level will slide down if blade is at up right position. which make this completely useless.

Love this thing. Seems to be very accurate.

Great for the Caravan

does what it's supposed to do

I find that the unit is accurate which is great. Magnets are strong and it's been very useful to me particularly in my wood shop on my saws etc. However one frustrating thing is that it is very difficult to zero out (which is fundamentally important to this thing) so I wish it was better in that department. I'm not completely unhappy with it, but that is one thing that could be better about it. It's still value for the cost of the unit, especially compared to other ones that likely do the same

Bon produit

I'm using this in a heavy equipment fab shop and overall it does what I need it to do. The only complaint - and it's a fairly major one - is that the magnets are barely magnetic. I ended up making jigs to hold it for my purposes, and it's reliable, but it would be so much better if it stayed where you put it... it's sensitive to two decimal points, afterall, not to mention the fact that it can barely support it's own weight while suspended.