AbramsSAE Class-1 Blaster 360 (Amber/Amber) 18W - 6 LED Tow Truck Construction Vehicle LED Hideaway Surface Mount Strobe Warning Light

The media could not be loaded.  This light is no joke bright you will see spots if you stare at it for any period of time. If you want to be seen especially at night this is the light for you. With a diameter of just under an inch this light will fit on the looser side in a one inch hole but being mounted in the tail lights the lights are super bright. The sync is in my opinion pointless because I cant figure it out quite yet. And the pattern switch is on the negative which doesn’t make much sense to me yet I guess but once you figure the settings I’m positive you won’t be dissapointed. This is also 5 pin wire for those who are curious,

They're bright for sure! I have yet to install them on to my Jeep, but let me tell you they're bright. Not only did I try them inside the shop, but with all the lights on and off as well as night and day time. I can say it was a bad idea to look directly into the lights...I was seeing a purple cloud in my vision for a good while. They are very well built. I'd say they look pretty water resistant (haven't tried yet but will update with a whole walk around of my Jeep). My only complaint is that it says they will to TBT which is great. I planned on using them close to my front turn signal and I come to find they will only steady burn in white...I tried changing the flash pattern and still didn't get a flashing amber light. But, I will still be able to use a turn signal and all will be fine. I just wish it worked like my Feniex Cannons do in my reverse lights...I also had a hard time getting them to Sync up...Maybe I did not have the wires connected properly? Probably my fault or I was not doing something right...when installed, I'll look more in to it all.Overall, a very bright and noticeable light. Very well built. With a good Colorado winter coming, I hope this helps people see me when I am pulling people out of the snow! Thanks for reading!Email me with any questions: [email protected]

When I opened the box and saw how small it was, my first thought was, "Oh boy ... I got ripped." Then I hooked it up to a battery to test it out - I was seeing spots for the next 10 minutes! Holy crap that thing is BRIGHT!! Exactly what I was looking for, for my new trike-launch paramotor. The default pattern is perfect - 2 quick flashes, and a brief pause, then repeat, pretty much like a general aviation aircraft. Touching the blue wire to ground changed the pattern to different ones, even staying on solid as one setting ... but in the interest of simplicity, I have left the blue wire coiled up out of the way, not to be used in this application. I have almost 2 hours of run time on it so far, and it didn't even make a dent in the 1500mAh lithium-polymer battery used for the electric start. Way cheaper than aviation-specific LED strobes. HIGHLY recommend for my fellow aviators, or anyone else for that matter.EDIT 8/26/2022: Still working great!! Have over 40 hours of flight time on it, plus it bounced around in my trailer from MA to FL, with the strobe body frequently hitting a support board towards the front of the ceiling of the trailer! Tough, long lasting, and a reasonable price. Can't do any better than this today!

I have an experimental airplane. When my $820 strobe supply failed I decided to take a $150 chance on three of these strobes. The 75fpm double flash is perfect. The under belly unit is switched independently of my wing tip units. The wingtip units work in sync using a third wire already installed in the airplane. I was able to use the original 3 wire setup for this. The LEDs are fully programmable and use 1 amp compared to 7 with the old strobes. I did have to make a special mount out of composite but it was so worth it. No more power supply noise in my radios.

The media could not be loaded.  The left tail light is Abrams, the right is a Sho-Me red strobe tube. I first installed a Whelen CSP690 with Sho-Me red strobes to my tail lights. I was not impressed with the brightness at all. So I bought these Abrams hideaway to replace the Sho-Me strobes and WOW,, the video does not do it justice....the Abrams is 10X brighter than the Sho-me!!! I ordered 4 more Abrams hideaway. My red/white light bar in back window is Abrams as well and that light bar is behind a 20% factory tint WITH a 5% tint on top on if, and yes, can still see it very good during a sunny day! I am highly impressed with Abrams products.

I have been outfitting my service trucks with DOT strobe packages for over 25 years. We used to use Whelen Xenon strobes with big high voltage battery sucking power supplies back then. Fast forward to today's LED strobes. Just as bright, easier to install, and far more reliable. We have recently been using several of the well-known LED strobe manufacturers' products in our new trucks and after trying the Abrams at half the price we're sold on them.

Super bright. Not a big fan of emergency vehicles using overpowered lights, and this is too bright for the intended and (advertised) purpose in my opinion as there is no night dimming mode, however it works great as an roof mount "360º" emergency flasher that's 1/10th the size of other units. The only improvement would be if they could somehow fit the driver/controller in the light head instead of in-line.

Great! Installed these in Nissan Frontier tail lamps. Replaced the turn signal bulb/socket with these and wired up the TBT function. So they are utilized as both turn signals or strobes when needed. They press fit right into the stock bulb hole. No drilling, screwing or gluing. Great product!------UPDATE 10/14:I have purchased and installed blaster 120s to sync up with the blaster 360s. They sync and work well. But I will say I have the blaster 120s wired for steady burn via reverse lights or an independent switch. If I activate the steady burn while strobes are activated, then deactivate the steady burn. All of lights will lose sync even though they are wired together. I need to turn them all off and back on to reset. Also if you stare at the lights on steady burn, they have a slight consistant pulse. Nothing too annoying. Overall very satisfied.

Very happy with the purchase. Colours are amazing. Useful and great quality. I highl Recommend it

I bought two of them. I tested a lot of whelen, feniex and other brands. These Lights are Very bright and high quality for the best price on the market. You can also put them into a single color pattern if needed