SUNLU Meta PLA Filament 1.75mm, High Toughness, Better Liquidity PLA Filament for Faster 3D Printing,Dimensional Accuracy +/- 0.02 mm,1KG Spool, Green

a budget friendly 2 pack for just over twenty quid seemed a no brainer ,especially considering its one of the better brands of filament i have used .the black unfortunately must have had some issue during manufacture or storage as regardless of your settings or speed it just spaghettied everywhere, occasionally printing the brim and support but not the actual thing you needed it for so i really cannot recommend the black one. however the white is without question the best white filament i have ever, used printed flawlessly with the default settings shown on the package and not once did it snap, spaghetti or clog.it even printed fine when i initially swapped it over with the black one and left the black settings there..the only slightly negative thing i can say about the white is it adheres to the bed too well and leaves some behind occasionally or it melds with the glue on the print bed and leaves me some unsightly mess.

got this for lightboxes, works great, can print thicker for fully translutent, or smaller to give it a frosted affect. Being Sunlu ABS its high quality and prints great at high speeds.

I really like printing with this ABS filament. I've tried a couple of others that are supposed to be easy to print with (eSun ABS+), but this always comes out the best.I've not had many issues with reliability. The smell isn't too bad and the print quality is excellent. I'll definitely be ordering again.

It's good filiment, not amazing or a game changer but it's good.How ever be careful if you put it in your filament dryer!I put it on to dry for a cycle when I first got it out of the pack it's just something I do as part of my process and my dryer feeds my printer also but upon starting a print there was a fairly loud knocking coming from the drier.Inspection: I ran a drying cycle at my normal 60°c for a set amount of time normally 6hours I find is fine unless it's been sat around for a while, after an hour the noise started so I stopped the print and opened the box and all looked fine so started the print again and watched how the filament was peeling away from the layer below it on the spool...... Ummmm it looked soft almost rubbery so stopped the print and pulled some by hand and it was sticking to itself!The filament had started to soften.... I mean really soften to the point that I could stretch it without pulling hard at all which would obviously cause all sorts of problems.So I ended that print changed the spool and left it to cool to do some reading up.Returned to the spool some hours later to find the whole spool had bonded to itself/melted together! Screwed a new spool of not cheap fill.Lesson: Don't put meta in the dryer at 60° or at all unless necessary, just thought I'd share this.

good nice flow but not a vibrant yellow

The filament is decent and prints well, but it's nothingl ike the bright yellow shown on the website - it's an _incredibly_ washed out light yellow. If the picture had been accurate, I would not have ordered this one.

Great product

Not tested yet but its Sunlu so it's going to print ok