XHF 10 Pcs 1/4" IP68 Strain Relief Nylon Cord Grip NPT Cable Glands Adjustable UL Listed and RoHS Compliant (Black)

The two smaller sizes might be inside the larger sizes when shipped. So if you don’t think you received all of the two smaller sizes, look inside the larger ones.The threaded locking back size is not long enough to use with a 0.187 thick box. Not enough thread to grab onto. There is a different version ASIN B07S9ZTF18 with longer thread but that version requires a larger hole 1/2 NPT for a slightly less than 1/2 inch cable whereas this version only needs a hole for 3/8 NPT or 11/16 which is available on standard step drills.They do have a separate washer to help seal. The other version with longer threads does not have a separate washer and it’s adjustment for tightening the gland around the cable is not as nice.

Although the product is all hard plastic, the new design for tightening around the cord is superior. A must use for contractors.

Very versatile on the cord size it can used with

IP68 UL Listed Nylon Cord Grip Waterproof NPT Cable Glands Asst 20pcs Cable Strain Relief 1/4", 3/8'', 1/2'', 3/4'', 1'', grey: Superb fit & finish. Solid high-quality item, far superior to commonly used rubber grommets. I like how tightening the unit closes the 'iris' (just like a Stargate) around the cable. The 1" worked especially well on my new kitchen range hood installation where the hood had a sharp edged metal hole for the AC cord. Highly Recommended.

These work great for strain relief, but the mounting sizes are in mm. For example, these should need a 1.250" hole to mount, but they are 1.299" or 33mm in diameter. Not a big deal when you only need to mount 1, just file or grind it out to fit. But when you need to mount all 20 at once through steel sheetmetal it's a big pain...Yes I can just use a 1.5" hole saw to make it work, but it makes for a sloppy fit.

Used to wire in 80 gal compressor, tightened down on 10/3 sj cord perfectly

For the 3/4" size, the thread OD is given as 26.41mm. It is, in fact, 30mm.It is listed as being a 3/4" NPT, and even has that stamped on the part. 3/4" NPT has an O.D. of 1.05", however, quite a bit smaller than 30mm. It is not 3/4" NPT. I don't know what it is. It is a straight thread of some sort, significantly larger than 3/4" NPT.So for my application, it didn't work. Other than that, it appears to be good quality.

I rated this 4 stars because it is an ok product and for the price a good value. However, as a low cost product, it has poorer quality than some other strain relief/cord grips which I have worked with. But I can’t really complain when I look at this part was under half the cost of the better built items.

I don't normally leave reviews, but this product is amazing. Dimensions given in the description are very accurate. For my application, I needed a cord grip that could fit my battery cables with a snug fit when tightened, while also fitting over the battery lug terminal, which is wider.After paying 3 times the price at my local hardware store, for something that did not accomplish the above, these items saved the day. They are quality made and are compatible with my other conduit conduit fittings of the same width. Fully approved for use in Canada; great price; you can't go wrong.Size purchased - 1"

fait la job