ORTUR Laser Engraver Area Expansion Kit, Extension Kit for ORTUR Laser Master 2 S2 Laser Engraver, Engraving Area is Expanded to 390 * 800mm(15.35 x 31.49 Inch)

We’ll be sure you order the correct one but the fit was great.

We purchased the ORTUR LM3 as our first laser engraver. We found it was quite easy to use and it was easy to set up with the instructions. We ran the Lightburn program with it and never had any issues. The air assist really made the difference as well. I would reccomend this machine to anyone who is just getting into laser engraving. They also sell a tumbler rotator so you can engrave tumbler cups.

Construido completamente en metal, con el adicional de expansión abre un abanico a proyectos mas grandes, aunque de la misma marca existen modelos con mejoras, este por el precio es excelente para iniciar, Lo unico malo son las instrucciones e imagenes de ensamblado muy pequeñas, por suerte en internet hay tutoriales para que el ensamble sea posible.

Although I had to figure out how to get my system changed it’s all good in the neighborhood. Made sure my height and with were set and useable.

This extension kit works great, includes all the parts necessary, and was really pretty simple to install.Only problem is the instructions to install it say to consult the original assembly instructions for the machine. I never even received those instructions, so I don't have them later down the road to follow. Not actually an issue, since I put it together the first time without the instructions, and had no problem extending that practice to install this kit. But, if you're not as familiar, not mechanically inclined, etc, just a warning.

I now am able to do a wider variety of projects with my laser. Pretty easy to assemble, just read the instructions and you be back to production in about 15-20 min.

Haven't done actual installation yet but it is good quality and ships very quick

This kit is great and doubles your work area. You can cut or engrave some fairly large projects in one setup once you've added this on. Installation was easy and fairly quick too. Another nice addition is that this extension adds belt tensioners to the Y-axis belts.Note that the instructions might be confusing with some of the newer Ortur Pro 2 S2 units like mine. In one step they have you reverse the screws on the lower 4 Y-axis carriages for clearance of 2 additional supports. My Pro2 S2 already had them reversed from the factory so there was some time wasted doing that and then undoing it. With the extension you need those screws to have their heads against the roller bearings (inside the frame) and the nuts on the outside of the metal bracket. So if check if yours are already reversed before doing that step.