Prescott Plastics 1 1/2” (38.1mm) Outer Diameter Ribbed Plastic Hole Plugs, Round Black Metal Tubing End Caps, Strong Furniture Leg Inserts, Impact & Weather Resistant, Made in The USA - 10 Pack

Worked very well to replace previous chair glide. Thank you!

Was a tight fit but will work; as opposed to the - 1 1/2”, which was too small.

Worked as expected.

I bought these to stick in the end of an acrylic tube I'm using for soaking dowels in mineral oil, rather than as a protective cap for a metal pipe. I was well aware based on the (very accurate) images that these would not be 'water tight'; but as expected due to their precise fit, filling the gaps between the ridges with silicone did the job to fix that for my needs.They came with the correct count and size, and required just enough force when inserting to know it was going to be a secure fit while not being difficult to use. The outside face is well made with no jagged bits to cause scratches on hands or floors. I would say these are a bit expensive but there aren't many other less expensive options that are likely of questionable quality so I'd say they are worth the cost.

Fit perfectly. I purchased these to plug the open end of my hi-lift jack and keep out the rain, bugs and other stuff. installed easily with a little encouragement from a leather hammer.

I found and used these last spring and decided I needed backups just in case. We use them on the ends of stainless steel tubes, such as the railings on our water slide and the railings on our two diving boards. In NC you lose inspection points if the tubes are open at the ends.

These had a good fit into the bottom of the table legs & they seem to be durable. I feel it was a good purchase.

Used these to replace the lost ends on my back Z-Track Mower rear bumper.More snug than the ones that came with the bumpers - tapped them in with a piece of wood - They are not coming out !!