Okin Bed Spindle Block Assembly for Okimat II Bed Motors

Was the perfect part needed to fix our bed where the lift had broken. It took a while to get, but once here was easy to replace and the bed works good as new.

our bed was too far under the headboard, and when we raised it, it lifted the whole (large) bedframe, and after that it would only raise the bed an inch and start making racket. I guessed a stripped gear, and ordered this spindle block. Took maybe 10 minutes to open up the actuator, and swap out the spindle blocks - and there was indeed a stripped out area that was hard to notice without a very close look. 100% solved my issue, and we're back in business!

Works just fine although it did need to be reversed. Was spinning the wrong way, you fix by switching the lead wires on the circuit board, didn't look like they could just be removed without soldering but they could, the ends were terminals.

Excelente

The quality of this assemble was good but I was not able to use the new spindle assembly because my old one has magnets in every other small slot in the white plastic gear at the base shown in this picture. The magnets are read by some sort of induction device having to do with the controls of the motor assembly. So first I tried to move the magnets from my old piece to the new one but they would not fit due to the shape of the new slots. So I was forced to use my old spindle assembly with the new push block. Fortunately my old plastic block was just stripped out and I was able to use my old spindle.

On my sleep number bed that I purchased in 2013. I have the adjustable base with the okimat 2 motor. The spindle block on the FOOT of my bed actually shattered so it was very hard to find the replacement. I looked everywhere for the part and it took me forever to figure it out. I received the part and took apart the motors casing and replaced the part in a matter of 20 minutes. However, I did learn from a youtube video that you have to put a little dielectric grease that has to go on the bearing and to make sure that the bed is flat before you put the new block in!! Well worth the money and time not to buy a new adjustable base or take it somewhere to get it fixed. Good Luck!!

block broke during first use.

The adjustable bed MUST be fully lowered before you can remove the unit which contains the Okin Bed Spindle Block Assemblys. (Our bed is a Sleep Number model). The bearing failed in our spindle block assembly. It should have been a thrust bearing rather than axial bearing. The repair part with shipping was around $60, far less than a service call. I'm very satisfied with the replacement part. No instructions were provided.

J'ai vérifié avec l'original et le block pour lever la tête du lit, les filet de la tige ne sont pas comme ceux du block pour lever le pied.

Funktioniert super als Ersatzteil für den Motor einen Boxspringbett. Einfach zu montieren nur wenn Motor ausgebaut ist.

Sehr gut.