onlyfire BBQ High Heat Gasket Replacement with Adhesive Fits for Vision Grill Classic Series

Product description says it is for vision grills. It is not long enough to replace all gaskets. After reading reviews on the glue sticking i decided to start with the chimney as long as you use a utility knife to separate there is no issue. Next i did the lower grill and then moved to the top grill i was short a little over a foot maybe a little more. This is on the vision grill that it is recommended for, total waste that i had was 1 inch.

When I tried to peel off the paper to expose the adhesive layer it came right off with the paper! I tried unsuccessfully to the adhesive layer back on the gasket. I have installed several of these types of gaskets before. This is the first time I have seen a product like this.

As others have said, not long enough for the grill and the top vent. However really disappointed that it only lasted 2.5 years when the original gasket lasted 5 years.

Just enough to do both lid, base and 1/2 of damper.

inexpensive replacement gasket. Enough material for my large Vision grill. Thick material provided an excellent seal. Was hard to find layer that the adhesive is on but once you locate it, it was easy to install. Instructions would help.

Held heat and worked as described and expected.

This item was terrible. The adhesive backing on the felt would not release from the paper. Obviously sat in a warehouse or container too long......piece of Chinese junk! Unfortunately I waited too long too Long to install it and was non-returnable.

I used the gasket for my pellet stove ash drawer. Works perfect

Ordered this to replace the gaskets on my Vision Grill. There was enough material to cover the bottom and the top but there was not enough material left to replace the gasket on the top vent as per the description. Other than that, it is thick, easy to apply and should do the job. Unfortunately, I will now have to find some gasket for the chimney seal. If I were to reorder from Onlyfire, I would get a gasket that is about 14' long not 12' as supplied. That would give me a few inches to spare.

Fit my Pit Boss K24 grill. One end didnt appear to be very adhesive so we'll see what happens over time. Wont be surprised if I need to apply high heat gasket cement at some point. I had about 3" to spare. Remived old gasket with an old chisel, wire brush, and grill cleaner spray. Took about 35minutes to get it as clean and dry as possible.

I used this gasket to seal my WSM door and lid and it works very weel. It clearly help to maintain the ambien temperature into the smoker.

Had enough to do my vision grill series B So far works really well no air leaks

This item only covers the top and bottom of a vision grill you will need more to replace the seal around the chimney of the vision grill.