TCP Global Brand Benchtop Gravity Feed Spray Gun Holder Stand, Holds Auto Paint HVLP Guns, Table or Bench Top

For me, I have an adjustable air gauge on the input line and the holder is too short (not tall enough) to accommodate the gun unless the holder is moved closer to the edge of the bench so the gauge is over the edge, this of course makes it easy to upset the entire thing. I fixed this my narrowing down a 2x4 a sliver to fit in the space underneath, and, using a spade drill to allow for the underside bolts. This allowed just enough room for the gun to sit on the table and be a bit more stable. Having the gauge on the end of the gun saves a lot of time as the amount of air flow is right in your hand and you know exactly where it is at.

… the function of this stand is reduced when both a cheater valve and inline filter are attached to the gun. Also does not sit solidly on the stand with the disposable pain container system on the touch up Master gun (Maspro 22).

Needs to be a couple inches tall so the the gun does not have to hang over the edge of the bench. I need to add a spacer block under it before my guns fall off the bench. Good sturdy unit thou and holds the guns very well.

It works fine, not the best bad not bad either. if you are looking for a decent stand that won't break the bank and last long, this is the one.

I needed a secondary spray gun holder in addition to the one mounted to my finishing counter. I like how it holds the spray gun in an upright position, and doesn't let it roll side to side like some holders. I stuck a big magnet underneath the holder to add some weight. On its own it's pretty sturdy though. Also accepts traditional HVLP guns like the LX-20. Plus it looks like it was made for Fuji spray guns with the blue finish. Nice!