Morvat Access Panel 12x12 Inch for Drywall & Ceiling with Door, Heavy-Duty Durable ABS Plastic & Easy Install Access Box, Wall Hole Cover Plate for Plumbing & Electrical Cables & Wiring, White

Always easy to install

This is the second one that I have purchased.

Perfect size and fit for what I needed. I may upgrade my other areas to something similar!

I bought this to cover my pipe and valve in the wall that connects to my spigot outside. It fit perfectly. The plastic door does come out of the hinge too easily. It's easy to take the door off but it will come off if you just have it open. They should have made it a bit better. You can pop the door open with a coin or screwdriver. It serves my purpose because I don't use the valve except in winter / spring to shut the water on and off. If you put this somewhere that is frequently used then this may not work as the door will keep coming all the way off when opened because the hindged area doesn't hold it in the groove well. I'm not painting this as it's in a closet..but they have it textured so it seems like if painted it would blend well with the existing wall.

The panel fit perfectly in the wall. The color is also perfect and the plastic is strong enough .

If you need an access panel, this is perfect and cost effective. You use an adhesive like liquid nails or epoxy to seal it against the sheet rock. It's thin enough so if you have to overlap a stud it won't affect anything.If you need fast access, like an emergency shut off behind the panel, this might not be of good use as it requires a flat head screw driver or similar tool to open (see picture). This is NOT a push open / push lock design. Hinges are basic. But again, this isn't for everyday access, so durability will be dependent of amount of use.

I used this panel (I used a closet) to give me access to an upstairs bath! It gave me added peace of mind being able to access this plumbing. Ultimately, it saved me a lot of time and work! It was easy to install. I was very pleased! Highly recommend!

I purchased this access panel to cover a hole I had to make in my wall to snake wires into my home. Since I need to be able to access the area to add or remove wires I wanted something that would allow me to close the hole but still open it easily.I laid this against the wall and traced the inside of the access square. When I cut the hole in the drywall I cut on the outside of the line. This allowed the frame to fit snugly in the wall. I used heavy duty construction adhesive around the perimeter of the frame and spread it out with a popsicle stick. I made sure to get the glue on both the flat frame as well as a small amount on the side of the frame. Once I pressed the frame into the wall, the glue filled in any imperfections in the cut of the drywall. After a few minutes I placed the door into the frame.The look is a much cleaner look instead of just having a piece of sheetrock screwed to the wall.