Shotgun Shell Holder - 12 Gauge Shell Holder / 10 Gauge / 20 Gauge - Match Savers with 3M Tape Made in Finland - Shotshell Holder Made of Heavy Duty P12 - Original Stage Saver by Rangenord

After trying to get an authentic Matchsaverz and not getting a reply for months, I went an purchased this. It does NOT come with mounting screws. The tape this came with was AWFUL and fell off - I prepped/cleaned the surface before initial installation. I used velcro and it is holding up well.Functions well, cheaper than the original, does it's job well.

Works and holds amazing did about 100 rounds in one session and had no issues with it however did have one malfunction where the empty shell being ejected caught the outer edge of the shell holder and caused a malfunction but was cleared in >1 second

This arrived early and appropriately packaged. Not a lot to it. It fits a 12 gage shell nicely. Comes with 2 screw holes and some double back tape to secure it. I can't imagine only using the tape. I'm using it on a pump slide, so can't fault it for not holding the shell tightly enough. After a few racks, the shell begins sliding off. I'll try adding a small strip of skateboard tape to see if that helps. After a few tries, it does make for a very quick reload.

Works as it should, I wish it came with screws so I could choose between adhesion or screwing it. The adhesion seems to be holding well, though I didnt really have a nice flat spot where i needed it.

Clean the mounting surface before installing and this thing holds great. I've tested it with a 1 1/8 oz shell, 200 shots later and it's right where I put it. The shell can slide back and forth but has never popped out.

Works Great on my Berreta 1301 mod 2

Great fit. Holds shells tight. It's my 3rd purchase. I would only request that simple directions on which side to install the shell holder towards the chamber. I intuitively installed the shell hold with the higher side (the shell holder is sloped) closest to the chamber and it works well for me, but then I noticed on the last one the "12" for the gauge size was upside down so I started to second guess myself if I installed them correctly and started testing with speed drills on which end towards the chamber worked best. The results were marginal. Anyway, I have them on three shotguns and highly recommend the product either way.

Attrocious shell retention and adhesive grip. Firing slugs or buck from my 1301 causes every single shell in this thing to immediately fall out. Not worth the money, especially if the intent is for this to be the last shell you have available to load.