TEN Factory MG22157 Drive Axle Shaft Assembly for Dana 44 JK, 32 Spline, 5 x 5 and 5 x 5.5 Bolt Pattern, Chromoly Left & Right Axles - Fits Jeep Wrangler JK Rubicon, Replaces: G2 96-2052-3-32

El producto se instala perfectamente, materiales, rodamientos y sellos de primera calidad

These are fantastic. Very strong. 2 bolt pattern holes, you choose the pattern and push the bolt studs in. For JK's, the pattern will be the inner holes, not the outer. I didn't have a press, but bought one at harbor freight and everything went on smoothly. A shop will likely try to charge you that amount to set them up and install them! There is a picture in the kit which shows you the order. Press on the tone ring, then slide on the retaining plate, then the seal. Then you put on the bearing paying attention to the picture for orientation, slide the collar on, and press it all down on the collar. If you are worried about the DIY aspect of this it's very easy. Very strong axles to support larger tires!

This fit my Jeep jk. My Jeep is not a rubicon, but I still have a rear locking diff. 32 spline axle is what it uses. If you do not have a shop press at home, find a local shop that does... I paid $30 for the bearings to be put on. Everything installed back on without any problems.

According to TenFactory the MG22157 are 4140 Chromoly shafts. I thought folks would want to know that since its not in the description. Everything fit perfectly in my 2013 JKUR. It’s only been about a month since install but so far so good!

I can't say if they are good or bad because I never opened the box. I could not find anywhere where they are made, so I called the company and found out they are made in India. I refuse to put global products on one of the few vehicles that is still mostly American made. Nuff said...