XFMT Motorcycle LED Wrap Around Tail Light Brake Running Turn Signal Lights For Harley Touring Tour Pack Road King Street Glide Road Glide Electra Glide 1997-2008

Purchased this light bar with run and brake light capabilities for a chopped aftermarket tour pack. I installed it on my 2011 street glide. It fits great and I removed the wiring ends and hard wired them with trailer harness. I purchased a 60 inch trailer wire kit tied the female into wiring harness under the seat. I connected the male end to the light bar wires in the tour pack. I channeled my wires through shrink tubing for cosmetic purposes. I made the connections in the left side panel. Lights works great. I saved a $160 using the trailer instead of the harley tour pack harness kit and looks.great. I give this light bar 5 stars considering the quality based on the price. I hope I helped someone by trying to answering questions I had prior to my purchase of this item.

Had to test fit numerous times and still got a gap. But other then that, works fine.

Plug ends are not as factory original. Need better photos of product. No template. 2nd attempt to return to seller & No response.

Fit and finish is good, mounting hardware & wiring diagram would have been very helpful, the connectors on the wires don't fit and Harley wiring harness that I could find, 5 trips & 4 hours later to my local Harley dealer to get the correct harness that runs back to the tour pak,,I still had to cut of the connectors, buy a blank plug, and 8 new pins, solder them onto the wires. still cant get it to work correctly.the whole light bar should stay light, and the blinker relay should break the circuit off and on. instead just the center light stays on, and the blinker relay completes the citcut to on and off.

works great a little big but works

Yes you have to figure out the wiring.No there is no template.The work great though and I'm pleased.I have a 17 street glide. I bout an '08 king tour pack which I put these lights on.I tied in to the tail light assembly on the fender. No perfect but it's clean and looks fine.I also used blue tape to mask the trunk. I then put 1 drop of red nail polish on each post and carefully pressed the assembly against the blue tape. That gave me mark where to drill.

Worked perfectly.

First of all Quality appears to be good.... all of the lights work and are bright. We will see what the future bringsNo template so you have to figure everything out on your own. Not a terrible problem, just cover the back of the tour pack with painter's tape, dip a little paint on the studs, position the light where you think it will go, press against the tape, then drill holes where the paint marked.Different color wiring would have been a nice touch. The turn signals COULD have been used as running light so having them blue wasn't an issue, as you should be able to tell right from left.The center section, having 2 blues and one black black is ground, but which blue does what?I hooked up a battery charger to the ground, then touched each blue wire to the positive to figure brake from run.When I have a chance, I will run a bead of clear silicone around the light housing gasket

Take note for you that does not have a led bar installed already, the little bolts does not come with, so you will need to find something that fit there.Prendre note que les petit boulons ne viennent pas avec, il vous faudra trouver quelque chose qui “fit” la...