Orion Motor Tech Wheel Bearing Press Kit for Front Wheel Drive Bearing Removal & Installation, 24pc Wheel Bearing Puller Tool Set with Sliding Screws Universal Bushings Sleeves Storage Case

Unfortunately, the nut that came in the kit did not have an internal rope, as if it had been a manufacturing error, fortunately I was able to solve it using the nut of a towing ball, it fits perfectly, the tool is perfect and solid, I have changed several sets of bearings and I have not had problems, the materials are very solid.... You won't regret it

Works great

Worked well glad there’s a paper instructions to show what pieces go where. Was a pain to do by hand but definitely better with atleast a mid torque impact it takes a 27mm socket and 32mm socket also grease the bolt! From the amount of torque needed to push out the bearing it won’t last long without grease. I used wheel bearing grease and I liberally applied it

The case is pretty much junk as it came cracked and everything out of place. But the actual tools do work fine

This product is a substitute for a real press. It works just fine if you go real slow and use a lot of penetrating oil to remove old rusted bearings. Even with that, I had one race that was very stubborn, so I used a propane torch to heat the race up. Also, tighten until it is good and tight, then back it off before tightening again. Spray rusted parts often with penetrating oil, especially after moving the bearing or race a bit. I bought this so I did not have to remove the suspension knuckle from the vehicle to remove the hub and wheel bearing. That took about 30 minutes. Replacing with the new parts went a little easier with this, but just a bit. Make sure to polish up the mating surfaces before putting in the new parts.I am satisfied with how well it worked, especially given the price.

This Orion Motor Tech kit is perfect for pressing in and out bearings and seals at home. It comes with a wide variety of sizes that fit most cars and light trucks, and the parts are clearly labeled and well-organized in a sturdy case.

Used this product to remove 30+ year old subframe bushings that are pressed in and extremely rusty, with some additional help form a blow torch and a 3/8 breaker bar, it made quick work of an otherwise painful job.All of the kits pieces are exceptionally robust, I had no issues with the threads stripping or wearing (like other reviews I've seen).Assembly is quick and easy, the bolt is even pre lubricated.There are plenty of sizes to fit practically every automotive application.The case is a bit flimsy, I did end up breaking it after I dropped it by my own fault, it is only plastic holding a lot of carbon steel pieces. To me this is a non issue, between the two bolts that are supplied you can carry all of the pieces on them for storage and minimize space taken up by the case.One thing I do wish was better is the length of the sleeves, I had reached full travel before the bushing bottomed out on the other side of the sleeve and used a rubber mallet for the rest

Tool is junk!!! I received the kit on Friday. I had wheel bearing to replace on a Ford escape early Saturday morning. The kit looked amazing on initial opening. I removed the knuckle and clamped it in a vise. I set the tool up as shown with the pucks and cup on the front of the knuckle. Installed the bolt in the center and installed the nut. Upon tightening the nut it would slip on the threads. Looking at the nut and bolt threads, found the threads in the nut is larger than the bolt. The Tool Is Useless!!! I had to get a local machine shop to press the bearing out. Do Not Buy, It's Junk!!!!