TjernlundVP-2F Side Wall Vent System for Water Heaters Up to 60,000 BTU

Very, very happy that it is made in the U.S.A. and it has a Fasco motor on it. This powered vent is really very quiet when running. I was however, disappointed in the noise/vibration isolators supplied. They are really cheap and definitely wont last more than a few weeks if you're lucky. I went to Lowes and bought large rubber stoppers and drilled a hole through them and used them to isolate the hangers, worked great. This unit is extremely quiet while running, can't hear it all from the 1st floor of our home.

No issues following the provided instructions. It took quite awhile for the install, but we had to modify a basement window and such. Just how the house is laid out. It works wonderfully is so quiet.We are having our roof redone and wanted to minimize the things that go through it. This was perfect and our cheapest option.

I purchased a home back in may of 2017 and after purchase realized the water heater chimney stack had been removed some time before. in removing, the natural draft water heater had no where to vent to. it was just venting into my basement. so my solution was to retro fit a side wall vent for it. tjurnlend came through with this product which is an excellent product. i purchased the unit which comes with everything you would need except the c or b vent runs. i installed in 3 hours, most of which was cutting a new 4 inch whole in my outside wall, the wall being almost 6 inches thick with old siding. the unit runs flawlessly as of now and is quiet to boot. im very happy with it, the water heater was only a month old when we bought the place and i did not want to get rid of it for a powervent water heater. so 280 bucks and 3 hours later thanks to tjurnlend i made my own power vent water heater. i would highly recomend this product. good construction, good quility and quiet.

I bought mine as an open box, so it was missing a few items, instructions, ect. (Got my instructions from the manufacture website) Key note, is that you need too mount the valve vertical, otherwise it won't work. (Don't let the picture in the instructions fool you. It shows the valve sideways. Needs to be up and down/Vertical) The motor has a lot of torque when starting and topping which causes the internal blades to hit the housing. I'm trying to work this out with some different mounting grommets. (Parts that we're missing). Really pricy for what it does, but it was the only option I could find, so I was sort of stuck.

Works great, a little noisy vibration comes from the unit. The rubber noise isolation mounts came apart the first day of operation.v

Expensive, but works as described. Will be able to use with replacement water heater later, so if it proves durable it will be cost effective.

we replaced a 21 year old vp-2system. changed everything except heat shield new one fit exact old system 24v .new millivolt. note remove old system solenoid gas valve.

Product was good and does what it’s suppose to do. Customer service isn’t the best