Ubrand SRT007-22-02U GCSLIPRING Conductive Slip Ring - Through Hole, 7mm Wire, 2A Slip Ring Brush Collector

Been working every day for past month

Worked great for me on a high speed spinning motor . If you have issues it will be things like attaching it to a power source that shared where voltage is dropped by other accessories ? I split the power source and it eorked fine

Bought this slip ring to make a holographic fan. This was the first two line rings that I’ve ever purchased. Upon arrival, they were well packaged and I set out to run a few tests. My design to was such that I could easily replace the slip ring without doing too much work. So I placed the ring in the assembly and it worked very well. I had to remove the slip ring to rewire so I needed to take off the slip ring. When I went to remove the ring and i lt split apart (inside ring separated from the outside ring). I was able to put it back together I secured it using a glue dot. Then I looked at the second ring and it had the same issue. Very easy to take apart. On this one I put a small strip of tape to keep it together. This should be tougher to take a part as it’s quite easy to destroy if handled too much.

Cheaply made both internal contact (which are real fine wire) broke after a couple revolutions.