60PCS Solderless Quick Splice Wire Connectors, 22-10 AWG Lock Snap Electrical Wire Connector(22-18AWG Red 20PCS, 18-14AWG Blue 30PCS, 12-10AWG Yellow 10PCS)

Needed these for my truck shop

Good product

Plastic could use a bit more heft to it but for what I paid its going to work just fine.

The REDGOOSE 175PCS Solderless Quick Splice Wire Connectors, for 22-10 AWG Lock Snap Electrical Wire Connectors came with 22-18AWG 75PCS, 18-14AWG 75PCS, 12-10AWG 25PCS.What I like of the REDGOOSE 175PCS Solderless Quick Splice Wire Connectors how easy it was to make a quick two wiring connection without splicing the wire. I used these quick wire connectors on my 7ft trailer to install new tow wiring hardness and I was able to complete the entire trailer in less than an hour. These Solderless Quick Splice Wire Connectors made the job too easy to install the trailer wiring hardness. After using the Solderless Quick Splice Wire Connectors on the trailer, all the lights worked as they should. I recommend these REDGOOSE 175PCS Solderless Quick Splice Wire Connectors for the different colored sizes and the price for the kit.

Easy splicing!! It is plastic, be mindful about age

Bought this kit for the various sizes, ended up buying more yellow ones. That's the size I used most...

Three different sizes for various gauge wires on my boat. Simply use pliers to press the blade into the conductors. No cutting is required! The blade is metal so you can easily take a voltage or resistance reading with your volt meter to ensure everything is OK. Then, the tab wraps around the connector preventing accidental contact. It locks with a distinctive click. I was able to connect my 25 watt Marine VHF Radio in just a few minutes without disturbing the wiring harness inside the console. Works well!

First of all, I am all for splicing, soldering and heat shrinking connections where I am able. I just did an alarm install on a car and did as many soldered splices as I could, but there are just some areas where I had no choice but to use these quick splices - some due to location with absolutely no room to get a soldering iron in or some wires that were thick gauge or ones I couldn't cut down for certain reasons. Nonetheless, these were perfect and the install went fast. The only complaint I have about these is how difficult it is to separate the two halves in order to get the wire down the one side, I had to pry it open a little with a screwdriver. Another one the blade bent when going to make the splice but I think I had the wrong angle on the tool I was using because that was the only one that bent. Overall, I will use these again in other upcoming projects.