Edge Supply Red Oak 2" x 50' Roll Preglued, Wood Veneer Edge banding, Iron on with Hot Melt Adhesive, Flexible Wood Tape Sanded to Perfection. Easy Application Wood Edging, Made in USA.

I used the product to finish off a bay window that we had replaced. It came with oak finish but the edges were not finished and showed the plywood. I used this product to finish the edges so the staining and the frame all came out looking the same stain. It worked beautifully.

i used this on a 72' round table it was perfect stains easy its real wood!!!!

So easy to apply even I could do it! A couple passes with a hot iron, trim the excess and your ready to finish. Sticks to plywood edges well; also found it sticks nicely to ANY wood substrate! Good stuff!

Hard to use a hairdryer.

Nice grain in wood glue is very good

I was skeptical, but thought what do I have to lose. The front door veneer had to be repaired, if not I might have to spend up to a $1000 for a new front door. Take your time, measure the area to be replaced twice, use a sharp blade. I applied the veneer and went over it with a hot iron, took about 2 minutes and was done. You can lightly sand it. In my case the front door was being painted so you can use a little wood fill or caulk to clean around the edge of the new versus old veneer. I painted the door and you cannot tell where I made my multiple repairs. Make sure the application site is clean and dust free and you should have no issues with this product it does it's job.

Worked very well and very easy to attach. Used it for legs on an end table. I also split it lengthwise and used it for the edge of a 3/4 thick sheet of ply for the top of the table. Just need to trim and looks great. I will update in future if it starts to peel

Excellent grain structure. Used to cover both printed and pine wood to rescue cabinets in a trailer. Excellent results