Fill-RiteNX25-DDCNF-PX NX25-DDCNB-PX 12V / 24V 25 GPM Continuous Duty Foot Mounted Fuel Transfer Pump (Pump Only)

I've bought 4 of these pumps now to replace aging GPI pumps on our service trucks and fuel trailer. When you put the Ultra High Flow Nozzle on the business end of the hose, these babies will flat move some fuel in a hurry.Be forewarned that you will need a piece of threaded 1 1/4" pipe (not included) to make the suction pipe from. I bought some 36" galvanized pre-threaded sticks from Lowes for around $20 each and then cut them to size as needed. Be sure to use some teflon tape on the threads of the suction pipe so that you don't lose prime there.These pumps are much lighter than their predecessors and their design is engineered-out the way you'd expect from Tuthill.This is the top of the line in fuel transfer and you'll be glad you spent the extra money each time you're doing the thankless task of refueling at the end of a long work day. If you have employees they will thank you too.

The power to the pump is supplied by special cable costing $150.The cable is 3 wire pos neg ground the GROUND MUST BE ATTACHED FIRST OR IT WILL SCREW UP THE PUMP.When making a pickup tube out of 1 1/4 schedule 40 pipe you must use Gasoila FasSeal ATS to "seal" the pickup pipe to pump flange or it will not function, it leaks past threads and pump does not work.Tuthill recommends a 45 degree angle cut on bottom of pickup tube, this will cause the pump to start to loose suction at top of angle and start to shut down. Tuthill recommends cutting pickup tube 3 inches above bottom of tank for suction tube to end. I did that twice it cut off 25% of my usable volume in 100 gal rectangular tank. I then measured from the top of the pump flange after installing it into the tanks' bung, subtracted .5 inch and angled bottom of tube maybe 10% and got the full range of tanks volume, still this pump failed and had to be returned for no suction.Tuthill has discontinued this pump and says different things, if it works it is great when it starts to fail it is no good.I now have 3 custom made pickup tubes and a different pump. All is good.

Pump is great but 75% of our equipment cannot run this pump. Blows the equipment fuses

Easy to install. Switch did come loose after a week of riding around in the back of the truck. A couple of washers in behind it fixed the issue.

ONLY PUMPS 14 GPH !!!!!!I’M A LITTLE PISSED AFTER SPENDING $1100