Edge Supply Walnut 3/4 in x 50 ft Roll – Pre-Glued Iron On Wood Veneer Tape – Wood Veneer Edge Banding Tape with Hot Melt Adhesive, Smooth Sanded Finish Ideal for Furniture & DIY, Made in USA

Beautiful. Don’t usually write reviews, but this was so easy to use and worked great. My first “veneer project” and turned out amazing. Love that it’s made in USA. Adhered easily. Would buy again. Some before and after pictures.

This stuff is great, I've bought many rolls of every size they make. The bigger 3" rolls often have a lot of figuring and look very nice. Thick, it can take more sanding than the thinner and more expensive walnut edging I've used.

I purchased this edge veneer for a speaker cabinet project. The rest of the cabinet is finished with raw walnut veneers. This product has a nice, even grain and consistent color. As far as color goes, I’d say it’s about 75% light, so 75% of walnut wood is darker than this edging, and 25% of walnut is lighter. For me, this worked well as the darker parts of the grain were towards the center of my panels, and this worked nicely with the lighter wood toward the outer portions of the panels (see photo). The glue layer is a little bit thick, which led to some white lines that needed to be sanded but it cleaned up nicely. Overall I’m very satisfied with this product for what I paid.

Great product and easy to use once you know what you're doing. The glue melts quickly under a hot iron and cools fast. Easy to sand smooth and get a flawless edge.If applied properly it can easily look flawless and provide incredibly durability to the edges of plywood. Aesthetics too obviously. Edgebanding with a hot iron takes practice and a few tips like back rolling are essential. Don't expect the banding to stay stuck just by running an iron over it. You have to get the banding in place, run the iron over the length slowly but without burning, then go back with a roller tool or I just use a 3/8" oak dowel and slide it over the banding to press it down to lock in the glue.

Very high quality banding with the only negative being that it is quite narrow when doing 3/4 plywood. There is almost no margin for error. Other than that it is great.

Worked well to bond to MDF

These are great, they're easy to use, and I've ordered a few more rolls since. They're slightly more than 3/4", so it's perfect to band 3/4" plywood. But I found that the white hot melt glue contrasts with the dark walnut, which tends to show on the final product. So I'm wondering if there is an alternative with a darker glue.

I was worried our kitchen cabinets would need some serious work, and money, but this stuff saved the day. It's easy to take off the old stuff (metal paint scraper) and easy to apply, just iron it on, trim, sand the edges, and stain. The repaired bits are all but indistinguishable from the original that didn't need repair. Biggest challenge, which wasn't that big, was matching the stain. I've been plugging away on replacing the bad bits but the cabinets look a whole lot better for this stuff.

Excellent product- First time I’ve ever tried to refinish my kitchen cabinets. The ones next to the dishwasher, the edges of the cupboards needed to be refinished. I scalped off the old chipped veneer and after a light sanding, measured-off new strips of the new walnut veneer. Using a clothes iron, set to linens, I smoothed over the veneer until it was solidly affixed to the cabinet. I used a dark maple Minwax stain- one solid coat was enough to match the existing espresso walnut cupboard- The whole process took under an hour and the cupboards look brand new!

Really nice veneer. Perfect for 3/4 in walnut plywood. Would buy again for sure on another project.

Excellente qualité