LAMPHUSCruizer Horizontal Bar Clamp Mounting Kit 1"/ 1.5"/ 1.75" (Includes 1 clamp) 2-Pack (360 Degrees) LBR100A91-X2

Good

Very nice brackets, If needed I would definately buy more of these

Ordered two sets, the fit was pretty tight on my 1.75" bar. One of the clamps failed when tightening after the bolt ripped the threads out of the clamp at around 15 ft/lbs of torque. Thankfully I had ordered two sets, so it was no big deal. They ship with double backed adhesive, which is nice. Overall a good kit, but the bolts and threads need upgrading to at least grade 6.

The screws are a little short for 2 inch diameter....I put a piece of shrink tube in there as a gasket between the 2 inch canister and bracket.

So far so good with installing the brackets for a light bar on the front of my 2016 Yamaha Wolverine. No issues so far. Went to Crossbar Ranch in Oklahoma and no issues!

These were the correct size to mount some fog lights to the telescopic forks of my motorcycle. The finish looks good and the fastening hardware was very good quality stainless steel. I didn't need the thick rubber spacers -- just the thin double sided foam tape that was included and they fit fine. The adjustability worked great for my application but check carefully to make sure you have room for what you are mounting. The struts that insert into the mounting rings have detents every 45 degrees for the two set screws that secure them. They will rotate freely where ever you need them but the detents in the struts are nice if they line up for your application. The set screws come to a conical point so they will bite into the struts wherever you tighten them down. This was cheaper and better looking than the factory fog light kit that Kawasaki sells through their dealers for the Versys 650.