Drain Line Adapter (DLA) With 1/4-inch Quick Connect Fitting for a Water Filter and 7/8-inch Fitting for a Dishwasher (ET116-001, D-25QC, DLA-D)

I’m not a plumber by any means. This piece went on very easy and I had no leaks after installation. It’s been almost a year

Works and fits perfectly.

This part does exactly what it's supposed to do. It's sturdy and seals up easily. Very nice having the ability to choose the diameter of your dishwasher drain hose. Mine was 3/4" so I just needed to cut it at the 3/4" line. Easy and reliable. An excellent American made product.

This connector works really well. I just needed the largest of the three pipe sizes, so cut off the end with the smaller two. Great product.

I highly recommend having an empty container to hold your dishwasher hose while you install this item to avoid making a mess under your sink. Note that dishwasher discharge may continue to show up intermittently.I have attached this product with my dishwasher. In the photo, you can see that I plugged the RO connection with a set of plugs I purchased off of Amazon as well. This is important so you can avoid leakages in case your sink plumbing back fills and you do not have an RO system installed currently. Without the plug, the backfill would leak into the sink cabinet.The instructions mention that you should use a hacksaw to remove the section of the barbs that are too narrow for your dishwasher. In some other reviews, the reviewers are complaining about reduced drainage from their dishwasher. This is likely because they did not consider this part of the instructions and just installed their dishwasher drain hose onto the adapter directly.The hacksaw portion is also important from a drainage perspective. If you are not concerned about discharge from your dishwasher and just want a secure fit, you can also use some Teflon tape to thicken the section that would be sawed off to get a more snug fit.I gave this 4 stars because the included hose clamps use a slotted screwdriver head, which is more cumbersome when working under the sink than a Phillips head. Slotted heads make it easier for the screwdriver to slip out of the groove and hit something. This is easily remedied, but I find the reduced ergonomics worth calling out when you are working in a difficult position under the sink.

I needed this for installing my RO water purifier under the sink. I was not feeling comfortable to drill tge sink trap for the waste water. Instead used this and it worked really well. The quality is also good working with no leaking.

I used this to install an RO water filtration system under a sink with a garbage disposer for a drain. The product saved me from having to drill a hole in my drain lines and use that ridiculous drain line saddle (clamp) that came with the RO system. Was also great to see that this product was made in the USA.

I used this to connect a reverse osmosis system under my sink. The system only came with one of those drain saddle adapters that require drilling into the drain pipe. I’ve got a garbage disposal, and after a bit of research, I learned those aren’t recommended with disposals.Found this on Amazon and it worked perfectly. I was able to hook up my dishwasher and run the water line for the RO system with zero drilling. Everything connected smoothly and securely. Install was quick, maybe five minutes. No leaks, no hassle.If you’re installing an RO system and want to avoid drilling into your pipes, this is the way to go. Simple, clean solution that just works.