OS SALES Fully Automatic Water Level Controller and Indicator with 3 Sensor for Monoblock Motor (White) for Upper Tank

Yes

The media could not be loaded. Working good for now.(Note: Have used finolex telephone wire(15mtrs) for the sensors connectivity)Pros:1. Automatically starts and stops2. Low/zero standby power consumption3. Easy to install and small in size to fit in almost all places(screws were also provided)5. No heating issue from the unit6. Whenever you want to start, just switch off and on the power supply to this unit. It will fill the tank and stops the motor!!(This feature was not there in Imagine technologies controllers)Cons:1. When ever you switch on the power supply, it starts the motor!!!! Even if the tank is full, it just starts and stops!!!2. Whenever the power goes and comes back, motor starts on its own.This may be more useful for the people who manually want to start the motor and forget about stopping! But later, they can switch off the controller unit, if they want to have a full manual-auto control! Cheers

I have purchased this water level controller on 21 July 21. I have purchased this as out of 3 or 4 similar listed products in Amazon it is slightly cheaper.However after using for 6 months I really rue my decision for buying this product.I have 3 tanks and have 2 other make water level controllers.This water level controller starts the MOTOR ON even though the water is above OL or above middle level mark and fill water till OH level.Whereas in othe level controllers if water is upto OL level pump is not starting till the water level drops down below OL level.I have pointed out this defect to the supplier but in vain.Because of this defect which runs the motor when ever the power is switched ON whether the water is there or not may lead to overburning or increased power consumption.I am fully dissatisfied and you may decide not to regret later.To understand furtherThe normal working is explained as below from other manufacturers manualWorking : As shown in the diagram out of three sensors, 1 sensor put at the bottom, 1 sensor put at middle, and 1 sensor at top level of the tank. When the water level in the tank becomes low, means water get down from middle sensor, motor get switch on automatically. The tank starts filling up. When the water level reaches to the higher level, the top level sensor sense. the motor automatically gets switched off

Only maximum one year it is working

Value for money, and water sensors too are provided along with this.Had to buy wiring and a Plug to connect...total estimated project cost was 2000 with 100Feet wiring more expensive than this product itself.

Nice product

It's very easy to assemble and working fine till now. Best way to save water too

There is no cap/covering for the power connection area. The case is simple cheap plastic. The motor turn on logic is faulty - it’s on when the water level is lower than the high point but higher than the low point in water tank - there is a time when we turn on the motor it just fills the tank in a second. So we can not automate it. This could have been avoided if the motor turns on when water level is below the low point on turns off as water reaches the high point.