Otc 6296 Pitman Arm/Tie Rod End Puller

Good product but check the size. Doesn’t fit F-150 Gen 1 Raptor tie rods though, had to use my two leg puller.

حجم صغير والبائع لم يوضح..

I have used this once and it was great. I used it on the outer tie rod ends of a Ford Econoline E-150. I put my 3/8" dr. ratchet into the top of the drive bolt, gave the ratchet two swings, and BAMMO, it was over. (Vehicle is not exposed to salt.) Very neat.I'll update my review if this tool doesn't continue to be great in my upcoming suspension hoe downs.Made in Taiwan, a capitalist country off the coast of China. Nowadays, made in Taiwan means great quality for a reasonable price, much like Japan did decades ago.________________Dimensions:Drive bolt can be driven with a 3/8" ratchet, or a 19mm or 3/4" socket or wrench.Opening of jaws: 1.1"/28.5mmWidth of interior just above jaws 1.8"/46.5mmWidth of interior near top of opening, just before quarter-round curve: 38.8mmMaximum vertical interior space between top edge of jaws and hole where forcing screw comes down through: 2.4"/60mm

the best I good get and promt service. thanks.

I'm replacing the lower ball joints on a 1998 Toyota 4Runner. This barely fit on the end of the tie rod, and one of the hook ends broke on the first use. Seriously disappointed

Excellent price.