Yaheetech 72.5" H Freestanding 4-Door Kitchen Storage Cabinet,White

When I have time, maybe I will write a full review. I've done many of these projects, I was a contractor for decades. First things first: Familiarize yourself with the parts and instructions.... use a highlighter on important stuff, and a pen or pencil to check off each section you complete. It'll keep you on track.... On this cabinet I spent an entire day putting it together and roughly the first 90" reviewing, cleaning and grouping the parts and hardware for upper and lower cabinets so you don't confuse them later....(literally calmly, and slowly roughly 8 to 9 hours). I think I paused for coffee or tea two or three times. I don’t even think I ate anything so maybe subtract an hour and yeah I know what I’m doing. You might want to organize all the parts go through the entire list read the steps carefully so you know what you’re looking at... then separate pieces by group. It’s a good idea to get some Windex out and give everything a good wipe down...... this things fairly clean but you'll get finger marks off. You'll see if there's any glue in the wrong places or any damage to parts. I’m one of those people that has patience and takes his time.... you'll need it seriously don't try to rush this thing. I probably spent the first hour taking everything carefully out of the box. I read all the directions first and I marked them with a pen and a highlighter on the instructions so I would pay attention to the things that were tricky. As she progressed through the steps, put a checkmark next to them to show that you're done with them and move on carefully. When you’re doing something like this, you cannot be too familiar with it..... Your expectations will be challenged, but your patience will be rewarded. Here's that word patience again. It is a good thing to go through the paperwork. Read it, mark it up , check that all the parts are in order. I even split the parts in the room. I worked on it with upper and lower cabinet parts a few feet away from each other. Lower cabinet to the left, upper part of the right. ....so I wouldn’t confuse them. You build the lower part first, then you build the upper part I made sure the lower part was square when I finally got it all together before I started to attach the top cabinet. If the bottom is not square.... then you’re in trouble. It's good to have a decent level at least a 2 foot one and if you have a right angle, you can really check to make sure cabinet is square. Right angles are pretty cheap. Sometimes you can find them at the dollar store and they are good enough. I use a couple of cheap ones to square the necks on my guitars and they work. If you put the top part up there on a bottom cabinet 'leaner' ( left or right) you’re in bigger trouble. I bought two other pieces from this company they make pretty good stuff if you assemble this thing carefully the entire time and you glue where necessary and wipe excess glue with windex (use a strong glue it will be more stable in the end) it'll work out..... and if you use a glue, it's a good idea to let the whole thing sit overnight before you stuff it give your glue time to work with you not against you. It actually came together very nicely. The handle holes are drilled off a little bit, but I’m not even going to fix them. I don’t let that bother me much anymore.. they could be drilled a little better with a drill press but when I go that far, I'm starting to question my sanity. The cabinet is nice and square. I had no problems and no missing parts. No broken pieces, nothing chipped. I consider myself lucky in that vein, I did everything by hand I do not use power tools on this. It might be tempting BUT: if they slip they’re going to scratch but even more than that you cannot feel when to stop tightening ....if you do it with a power drill even if you back off the torque; It’s very easy to overturn the cam and begin to split the "manufactured wood" product. This is mostly an engineeref MDF type of material and/or soft pine probably underneath. This stuff stays strong if you don't split it. Clamp and glue it if you do and quit for the day.... it'll need at least 24 hours to cure your adhesive....then you can proceed. SPEED KILLS PATIENCE PAYS‼️ Wishing you all the best of luck I've seen quite a number of thumbs up on this one so I hope it helped you all. Really you gotta be patient you gotta use your head and make sure you have a handful of good tools. Nothing comes together any good with junkie tools. Update: August 2025, a couple years later I got a little bit of spread with the upper doors at the bottom .....a couple millimeters wider than the top. I figured that might happen just a little bit of cabinet bowing from temperature and humidity changes. The Cure: no not the one with Robert Smith, but this one, I put a shim under the lower hinges , underneath the hinge plates and screwed them back in place ....pretty much closed the gap. The cat likes this thing as well and I haven't scratched it up. It still looks nice to finish is nice if you get anything on it just clean it quickly. Don't let whatever it is Sit there too long. It can still find its way into the cured emulsion in the paint. Quite a marathon I did here holy crow‼️

Bought the black one for my bathroom remodel and love it! It uses nice big screws where needed and 4 triangle corner braces & screws to keep it square. Mine is in a corner and since I don't have small children and it seems sturdy enough for me, I didn't attach it to the wall, but that option is available I only have four cautious. 1. Took us 2.5 hours to assemble, but instructions were accurate. 2. Leave doors open to air out overnight. About 3 hours after assembly, I opened the doors to start filling it and the chemical smell was obnoxious. 3. I'm not a fan of the cheap, thin back panels all the manufacturers seem to use. They bend & break so easily, and I don't think these will be any different. 4. Some of the paint is worn off in a few places, nothing big, but everything shows on black. Luckily, I just gave my bathroom a black accent wall so I have Tricorn black paint to touch it up with.

This is a nice unit. The drawer’s a little rickety and assembly could be easier, so get ready to be patient. It will take 3-4 hours. Where you see SMALL depressions where screws will later go, consider deepening those depressions a little before inserting the screws. The instructions for attaching the drawer rails to the panels are confusing. Just remember the wheels for the rails attached inside the unit go in front and down so the drawer slides in over them. You will have a hard time screwing in the rails. It’s the worst part. Anticipate needing to come at that more than once until they nest flatly enough for the drawer to roll smoothly. Hang in there: it’s nice once it’s done. This is my second one, and I’m really pleased.

I bought this to use as a kitchen pantry. The doors feel a little flimsy but if they're treated with basic daily use and not superhero Hulk strength like an animal it'll work just fine for you. It's heavy and sturdy. Spacious. Adjustable shelves. I love the drawer in the middle and I like the overall look of the cabinet. Plus, the top sinks about 2-3 inches down for extra storage, so we have a new hiding spot for the oreos. Assembly takes a while but if you take your time and pay close attention to what you're doing it's actually not that hard. Kudos to the engineers who put the instructions together. Great product for the price! We bought another one for use as a linen cabinet. I would recommend it.

After reading some of the negative reviews, I was worried about purchasing this. I was pleasantly surprised. 1. Shipping - Arrived 4 days earlier than expected. The parts were enveloped with styrofoam. No dents or scratches from shipping. 2. Parts- Parts were all included and in perfect shape. No manufacturing defects. Boards are mdf (not paper as someone suggested). Parts were clearly labeled. Holes were accurately predrilled and everything lined up. Extra hardware was included if needed. 3. Instructions - Instructions were about as good as it gets given that they do not use written language. The diagrams are clear, everything is labeled by part number. 4. Assembly- Yes, furniture assembly, especially for a piece of this size, is going to be time consuming. It can feel overwhelming unless you take it step by step. If you have never assembled furniture before, this may not be the piece you want to start with. Quality - my grandchildren will probably not fight over this piece after I die. But for self-assembly furniture, I think the quality is as good as can be expected. The drawer opens smoothly, the cabinets close securely. The base is very solid. Handles - I didn’t care for these and replaced them. This piece requires 5” handles, easily found on Amazon. I did use the screws from the included handles, though. All in all, I would say this is in the same league as an IKEA piece when IKEA gets it right. I am super pleased with it and recommend it to anyone who understands that furniture that one assembles themselves is not going to be heirloom quality.

The pantry came in 2 separate boxes that arrived together and quickly. Actually having 2 boxes and thus assembling the unit in 2 halves made the process much more manageable. All the parts, hardware and instructions were complete. Nothing was missing. Although the instructions said it would take 90 mins, it actually took me the better part of an entire day. All the pieces and parts fit together perfectly with no issues. Just go slowly and insure you do all steps in order and correctly. I only needed help to lift the completed top half onto the lower half. The completed drawer and doors all work perfectly. Overall it is a bit flimsy but once it was loaded it seemed to be more stable. With children it would be a good idea to use the included wall mounting brackets. My cabinet was perfect and a great value. I would recommend.

The assembly was not hard, nor were the instructions difficult to read. I did have assistance putting the top piece onto the bottom, but otherwise I built it myself. Everything lined up and I did not have any trouble getting things to slide into place. It is not the sturdiest piece (wobbles slightly side to side), so if you have kids, I would plan to mount it to the wall. I believe the price is a little steep for this cabinet being MDF and not a solid build. There was a slight scratch to one of the backing pieces, but otherwise no damage. It does come in two boxes and UPS delivered together. However, I like the style and I had trouble finding one that I wanted. Overall, I am satisfied enough to purchase a second one. I'll update if my review differs from this one.

Beautiful pantry that helped me create a ton of space in my small kitchen! The directions are clear, but you need to take your time and pay close attention to the way the drawings are oriented because it is easy to mess something up if you don't. It is very similar to putting together Ikea furniture. Once finished, it is very sturdy - I don't think I even need to attach it to the wall, though it does come with an anti-tip kit. The magnets on the doors are strong and they align perfectly, the drawer opens and closes easily. You can tell the company cares about the stability and longevity of the product.