DEWALTMetal Shear/Cutter Drill Attachment, Impact Ready, 360 Degree Pivoting Head, Cuts 18GA Material (DWASHRIR)(Yellow, Black)

I needed to replace the fascia on a manufactured home. Because the dimensions were not the standard 6 or 8 inches, I had to do some 16-foot cuts down the length of the aluminum fascia so it would slip under the drip edge and sit flush with the vinyl soffit. My 64-year-old wrists were not going to enjoy that, so I figured that for the price, this was worth a shot. Boy, am I impressed. The tool fit onto my Porter Cable drill and functioned with no problems, and it literally took less than a minute per piece to cut the entire length. Since this only leaves one flat edge, I kept the scrap side to my right. It cut the aluminum like butter, and the remaining cut edge was perfect.I also used this to cut 12-inch holes in a plenum to add some cold air returns, and it worked great. The jaws do not open very far, so going over corners and bends is not so great. It also takes some effort to cut across a seam. It is not a cure-all, but for the price it is a great tool to have in your arsenal.

These worked great to build a supply plenum for my new heat pump. I was using aviation snips but after cutting 3' of 26 ga sheet metal I needed to improve my tools or risk arthritis. These work great, and are cheaper and store smaller than a dedicated cutter.I have a Ryobi drill and driver - both worked fine with this but it doesn't clamp nearly as easy as it would to DeWalt tools. However once attached it got the job done and was very easy to control the cut.

Great tool works fine. Can adjust to any drill or impact.

I needed to cut some metal corrugated roofing and I am definitely not a professional roofer. We recently had some roofing done and the contractor used one of thes, almost effortlessly. I bought one and it took some effort to get the roofing panels cut to the correct length. I was able to do an acceptable job but not as good as the pro would have done. Still, it was a much better than using a pair of scissor type shears: less effort and less time and strain. I would recommend these for light metal cutting. They do work and cutting in a straight line or gentle curve is relatively easy.

I’m a sheet metal worker and in my opinion these are better than the Malco shears. They have an adjustable clamp that goes onto your drill and you can set it at any angle that you need to cut at, this way you only need one hand to make a cut. These cut quick, are easy to handle and don’t leave deformation after cutting like the Malco shears do. Definitely recommend.

Works well, however it is best suited for flat material. It's still worth the money.

Tool works great for cutting mild steel. Easy to control the cut.

Adjustment screws seized in place. Stripped heads attempting to tighten bracket. Works well but had to fight with it as the mount continued to come lose.