6.35mm (1/4inch) Female Mono TS Socket Panel Mount Jacks, Patch Cables, Microphone Connector Adapter 6 Pack

Was wiring my deck for speakers and wanted to install Jack's to remove them. The Jack's worked very well.

I purchased these for a small project I was working on. The are well constructed and easy to work with. I had no issues with installing into a project box or with soldering leads. Good product at a good price.

Perfect for the hobbiest. May or may not stand up to everyday commercial use but the price is right.

These are just female mono plugs, but what I’m going to use them for will make them a wonderful addition to my studio.

Worth the money and easy hookup

These are without a doubt the cheapest female jacks I've ever seen. I just kept the nuts and threw them in the trash. A ground terminal bent as soon as I opened the bag 😂. And the ground barrel spins within the insulator! No way would I ever use these for my own musical gear builds or especially a customers. They should be ashamed of themselves producing such junk.

Cheap, I had two break in pieces when installing.

Got these to build a new guitar pedal, I was very disappointed when I went to use a nut driver with a T handle and found that the center ring would spin and ultimately make contact with the ground tab with a super light hand tighten torque level. I ultimately tried to hold the rings apart with one hand and tighten the outer nut only to feel that the mounting bolt would not tighten because the center ring was free spinning. I tried 4 out of the 6 in my package and said I give -- this is going back FAST!In summary: What a waste this item is cheaply made with no quality control.

Good

Exactement ce que je cherchais.

very cheat made and the positive pole does not lock into male jack. it is too long, just touches it. not a good tight connection.

Very poor quality. If you tighten just a little too much the jack will short out. Definitely not for secure and fail safe connections on musical instruments.

I used 4 of these connectors and 1 of them broke. There was a ring that is held on to one of the solder terminals it broke off. also i had to physically adjust the tip connection as the mechanical contact was not seating correctly.