R232-9 Epoxy Glide Roller Cover, 1/4-Inch Nap, 9-Inch

Works good with Latex paint

We used these for a DIY epoxy floor in our garage and it turned out great . These roller held up great and did not leave anything behind in the expoxy . We ended up order more of them as we were really having with the result . I think they would be great for any epoxy floor project .

It made the job of epoxying the 600 sq. ft. garage floor easy and quick and rolling out the epoxy went on smoothly. Did not leave any nap behind, I only used one roller.

"Durability" rating is a joke and I'm tired of pointing out dumb rating selection. They're single use rollers if you're on a job to make money. If you're an old timer, you'll spend an afternoon squeegeeing them clean and use them again ten years later so perhaps the durability rating is for an extended re-use period (nobody makes uncoated paper core roller covers any more). On to actual feedback. These do work great for epoxy floors and I'll keep buying them for that purpose. Fun fact, I'm never going to clean them for re-use, so I'll never evaluate "durability" as more than three stars. Unless they mean "did it fall apart on the job" then it's five stars all the way. They should switch the rating to "shed resistance" which would be useful for a roller and I'd rate it four to five stars. Nice packaging, though, comes with a plastic roller cover and end caps which is helpful for bulk storage.

Work very well. Never had a problem with lint or knapp coming off in the coatings. Does a nice job of holding the thick coating. Only downside is that it introduces a lot of bubbles in polyaspartic. Going more slowly helps a lot, but time is important when spreading catalytic coatings. Mix smaller batches and take your time when using these, or have more help on hand to evenly spread your coatings with these rollers.