T10 Wedge Base LED Bulb 12V DC 1W, T5 T10 Low Voltage Landscape Light Bulbs, 4 Watts Incandescent Bulb Equivalent, Soft Warm White 2700K 10-Count

Easy any incredibly bright for 1 watt

Not quite as bright as I thought they would be. Fit my lights great but I just don’t have the light I want

I couldn't get one circuit to work but I don't think it was the bulb;s problem. WhenI get's a littl ewarmerI will analyze the problem. The other bulbs worked fine

I bought these to use as replacements for my older Malibu brand outdoor low voltage lights. I’ve been using them as the original 11 watt incandescent bulbs burn out and not only do they provide the same warm color and brightness, but they use less than 1 watt in power. The oldest bulb is over a year in service and so far no burnouts.

When I received these bulbs I read the manfacturer info sheet that stated they will only light with 12v DC power. I have an old Malibu 12v AC transformer. I plugged them into the sockets fed by 12v AC and they lite properly. I measured the voltage at the sockets and it was 12v AC with no DC component. They could be a bit brighter and they haven't been in use long enough to determine how long they will last.

Should’ve made the upgrade a long time ago. The incandescent bulbs they replaced were prone to burning out. We’d have to replace 1 of the 10 incandescents every other month. PITA. These LEDs generate very little heat, use a fourth of the energy, and reliably come on every night. Get ‘em! 😊

Our older Malibu landscape lights runs on a 12V AC transformer. I've used other brands/models of LED replacements intended for DC that work just fine on 12V AC with no flicker. Unfortunately, these bulbs do have a very noticeable flicker when running from 12V AC, so I can't use them. Too bad since I like them in all other respects: fairly warm color (just a tad whiter than an incandescent), small enough to fit well in smaller landscape fixtures and brightness about the same as a 4W incandescent T5 lamp, which is what I'm replacing.Note the description does clearly state "12VDC use only."

I used these bulbs to retrofit/update the incandescent bulbs of LX Track under cabinet lights. These bulbs fit directly into the LX Wedge base. They function but they flicker quickly because the LX system uses 12 volts AC power and these LEDs bulbs are intended for 12 volts DC. The flicker would be equivalent to the frequency of their power source which is North America should be 60hz. So they flicker 60 times a second. Hardly a deal breaker.I have 50 of these bulbs underneath my cabinets, with all of these together I can only notice the flicker when I’m looking closely underneath the cabinet and because I already know it’s there. My wife says she doesn’t notice anything.The energy and heat savings of these bulbs is significant enough to offset that one drawback.

I have used these for the rear car registration lamps on three cars.The brightness is spot on, nice and bright but not too bright like other brands.They fit perfectly and as the description mentions you may need to remove and switch the contacts to get them illuminating. The quality seems good.

Good for the price/quantity ratio. The 1st bulb I plugged in had an intermittent flicker that was extremely off-putting when riding my motorbike at night. I tried gently expanding the bulb terminals & gently tightening the bulb electrical plug, but this made no difference - the flicker continued. I eventually swapped it out for another bulb from the pack and it currently seems to be working ok. I hope this continues, but I have 8 other bulbs if needed. Will update if/as needed. Thank You.

Lampadine a LED senza lode né infamia, fanno il loro dovere.

Parfait

As expected, these cause errors on the dashboard. Not sure what I'm going to use the other 8 bulbs for?