Stainless Steel 1.2mm Thick Brushed Kitchen Splashback (600mm x 700mm)

More rigid than expected so good value for money. I trimmed a tiny piece of the corners with a dremel to fit under my curved extractor hood and stuck in place with some silicone so i can remove in the future if i decide to change the colour. Bonded really well and protective cover peeled off really easily leaving a pristine finish on completion. Was easier to install than expected and has a nice finish that matches my extractor. My only complaint is the brown packing tape used to hold the sheet inside the hardboard packing was a bugger to peel off as it kept breaking into small bits. Well packed and protected just fidly to remove the brown tape. Took me longer to remove the brown tape from the back of the sheet than it took to fit. Acetone removed all the tiny bits of tape

This product is thick, I installed over tiles and it covered them perfectly. I used a lot of no more nails, and supported the bottom with a large spirit level for 10 hours, stuck solid. Wipes down with a bleach cloth and leaves no streaks, am very happy so far

Ordered a custom size no problem making the request of with a helpful contact. - Unfortunately factory was too eager and immediately despatched a standard size. 2 messages later the correct sized splash back was delivered just 24 hours after the first one.Anyone can make a mistake - its a pain but I can't fault how they responded to put it right. Would use them again without question.

No adhesion! Triple checked to make sure there wasn't additional backing film. There wasn't, but not an issue for us as hubby fixed it using screws and some fancy brushed steel screw covers (sold elsewhere online). Very easy to cut to fit round a plug socket. Looks great behind my cooker, easy to clean with just soap and water. No issues so far. Will get more for other areas in the kitchen.

Excellent quality. Arrived early, very well wrapped with instructions to carrier to take care/fragile and to the buyer not to open using a knife. Definitely recommend this product and company

There is no adhesive backing to this productAlso although 1.2mm thick it is very heavy..hence I am drilling and mounting with rush steel cap screwsQuality wise this is perfect for my new kitchen once fittedJustA heads up but the mirror side is the back of the splashback not the front🤣🤣🤣Made that mistakeCompany were quick to rectify this when I posted the questionNice item really nice👍👍

Had a slight dent in when I received but once up can only notice if you know it’s there.Value for money amazing it’s made all the difference in my kitchen.You need to buy a stainless steal cleaner but cleans with ease.Also had to use extra adhesive and a wood plank underneath just till it set as is quite heavy and can slide. It’s been up a few months now and hasn’t budged an inch looks fab very happy.

Nice thickness . Not cheap rubbish. Clean with baby oil or wd40 and you’ll never see a bit of rust and gives a perfect shine