Lithonia LightingFML4W 48 5000LM 840 TD 4-Foot FML4W 10-Inch Wide Housing 4000K Cool White LED Wraparound with Triac Dimming, White

Had a bathroom that could not add a light this 1 light made it bright enough.

My kitchen had older, ugly fluorescent light fixtures, two of them which gave off a yellow type of light. I have same fixtures in garage, who would do that? Some builder apparently.Recently the ballast went in one fixture which was my opportunity to get rid of the nasty old fixtures.I knew I wanted led and I settled on these Lithonia fixtures. The first time my installer snapped them on I was so pleasantly surprised at the white light flooding my kitchen. It's the type of light you get on a clear sunny day outdoors.I have a white kitchen with blue accents and everything is just so much prettier with these lights and the fixtures are also lovely with the curved shade covers ( I do not know what they are actually called). Very modern and clean lines. I could not be happier with these lights and knowing I do not ever have to buy light tubes and get up there and change out is an added plus.

As far as ease of installation and brightness this light fixture is about perfect. I found the light defuser to be undersized to the point that there is only 1/4" or less of plastic on the sides holding it in the fixture, it is also cut so short that it doesn't extend into the ends of the fixture more than a 1/4" as well.One light tap and the defuser is going to fall out, there is just about nothing holding it in place. When putting it in place, one gets the ends right and the sides fall out, get the sides right and the ends fall out.It is very tedious getting this defuser in the place where it will stay. You can see in the picture there is almost no overlap between the defuser and the light housing.

This was a replacement for an old florescent light fixture that was in my laundry room. I ❤ it ! It gives off a bright white light, well made, and looks great. It doesn't have bulbs, but has two strips of some sort of material that actually illuminates the fixture. Installation was easy, 2 screws. 👍

The back has many protruding screw ends and other junk. I had to grind down two of them. I then placed 1/8" shims on the back.

Arrived cracked on one end with a completely misshapen frame, but since it would be such a pain to return I installed it and tried to hide the damage. Terrible quality control, I recommend avoidance.

Perfect light for a spot in my basement that needed better lighting. I replaced a standard 4 ft. fluorescent T8 tube fixture with this and glad I did. The lumen output was better than expected and the light quality is superior to other LEDs I've tried. Though mounting isn't as convenient as I would like, I will consider buying two of these to replace other LED fixtures (with lower quality light) I have installed in our garage.

Good light but lens removal and installation is a bit kindergarten. For the price it should be a lot easier. What’s so hard about a removable end cap?