DEWALT Right Angle Attachment, Flex Shaft, Drill Attachment, 12-Inch (DWARAFS)

This device is great! I can get in tight places. Handle removes to get in tighter places. Love it. Seems to be built well.

this is one of the best tools I have

I bought this angle drill to drill out rusted screws on my GM ABS module in my Safari van... I cursed GM engineers a lot while I did the job but the angle drill was a great asset... combined with some good drill bits I got the job done. this drill is well made and the handle can be moved to which ever side you need it on which is a good thing... I was working in a tight spot where I really couldn't see the screw I was drilling so that handle was useful to see if I had the drill straight up and down and not at some strange angle ...if you need a tool like this I recommend this one.

This Dewalt flexible extension works great, does exactly what it's suppose to do. It doesn't like the dirt unfortunately, needs to be built more durable. I use it mainly for pulling stakes from concrete forms, where most the screws are in the dirt. Great tool, saves the back and the drill. Would recommend

Just what I needed to get into tight places!

I am taking a break and using this to reach way back, drill a small pilot hole, then screw in the L brackets for our new sliding shelving units I am installing. For alignment purposes (soft close, either you are dead on, or they don't catch) I must leave the shelve attached to the L brackets and slider units and only have 8" top clearance & must be able to reach back 22" while laying on the floor. Considering the size of this units angle rotation head, best to keep it to small screws and drill bits. You cannot use this for heavy construction needs or large or long screws. The head is magnetic and has a catch latch that must be pulled back to release the bits. Also, the catch latch has a strong magnet providing hands free screw retention. I have bent the spline into an 1/2 circle getting into tight spots and spline is still working fine. The only two spinning parts is the head where the bit goes and the back that slips into a hex driver, saving those embarrassing tool marks often left by chuck mishaps. It comes with a small handle that threads onto either side of the angle head. The handle is hollow and has a removable cap and holds several small bits. Instead of killing myself and using a stubby and muscling in the screws after using an awl, this has made the install clean and easy. I would recommend no more than a #8 or #10 x 3/4 to an 1" max as the head is too slender to contain beefy gears.

handy tool. works good. very nice.

I call it my “personal touch”