Tools Hole Saw, Bi-Metal, Speed Slot, Arbored, 2-1/2-Inch (1772954)

Well made will stand up to professional use

Used this to cut a hole in the dash of the bridge on my boat for tilt switches. It worked very fast and left a clean and precise hole even in the fiberglass. So it’s very accurate. Blade stayed sharp throughout the project and I still use it. Fit perfect in my Ryobi cordless drill. Great price for functionality.

This hole saw cut thru the steel plate floor like BUTTER. Fast. Not bad cost. Great quality. Recommended.

Works like a charm. Great buy, considering it comes with the pilot drill attachment. Used it for cutting multiple holes in 1/2 plywood. After some use, I was able to get the plug to just drop off without any prying. Seemed the easier/slower I made the cut, the more likely I was able to just run the drill for a few seconds after the cut and the plug will fall out (3 out of 5 times). High quality product. Will likely purchase other sizes as need in the future.

Good quality.

I used this to cut holes in melamine boards. I put some tape on the front side of the board and backed the boards with some scrap wood to prevent breakout on the reverse side and it did a great job cutting the holes out cleanly even on melamine. This cutter seems to have more teeth than some of the others I've seen so I'm guessing it cuts slower but more cleanly. To be clear, this is the only hole cutter I have as I purchased this for a specific project, but it did what I wanted well.

I used this to cut holes in metal HVAC ducts to install UV lights. Gets the job done with no complaints. Keep in mind you need some power behind this and smaller cordless drills will struggle or not work.

Made quick work of a hole through the firewall I needed that had dulled two other cheap saws I had sitting around. Finished a project in a matter of minutes that I had spent hours on before that. Having the right tool makes all the difference.

Went right through the wall no problem.

Quality tools make works so easy. Cut through wood like butter.

I had been using a Benchmark hole saw and although it was fine for the thin layer of metal, it did not work for the thicker, so I ordered the Lenox hole saw and it finished the job in less than a minute. I should have ordered the Lenox to start with. Very pleased.

Bought the cheapo ikea one for their led puck lights. Took 5 minutes of smelly dusty cutting to break through my cabinets. Bought the Lenox. Did the job in 20 seconds, cleaner and with less dust. Highly recommend.