D3536 Brushless Outrunner Motor 1450KV RC Electric Motor Fixed Wing Motor for Aircraft UAV Mini Multicopter RC Plane Helicopter Robotic Arm

Great little motors at a good price. I have several of these same motors in several of my airplanes. I have yet to have one fail on me, except for one that I put too large of a prop on and ran it too hard and burned it up. (Totally MY fault, not a manufacturing defect) There are a lot of companies that sell brushless motors that look EXACTLY like these, except in different colors for 2 to 3 times the cost.

That was just the title, didn't mean to send it 😆. I had destroyed a brand new motor and had to rebuild the plane. A friend of mine in my flying Club told me of this motor! I trust him as he builds a lot of planes. How can you beat this price? I found the performance to be at least as good if not better than original equipment! It has enough power that I could go up a prop size according to specs! I will get back to you on that, very pleased, highly suggest this motor for replacement and hobby building to your choice, great motor!! I bought a second for my Valliant. I will most likely but a 3rd for my glider. Highly recommend, the description on the motor doesn't affect the quality of the product itself.

I put this in a 50" Stevens Edge 540. Powering it with a 3S - 2200mAh LiPo battery with an APC 12X6" propeller and a 40 amp ESC, it has power to hover, punch out and climb vertically (unlimited) with 6 - 7 minute flight times. Nothing wrong with that.

Great motor! Great price!

Delivery was faster than expected, motor has more tourk then needed and plane is almost never Flown past half throttle. Will buy again when needed.

Got the 750kv to replace an eflite motor that burned up. Eflite bolt pattern is weird but made it work. Went from pulling 70 amps on a stock 60 amp avian esc on stock motor and constant overheating to pulling 30 amps with esc temps below 90F vs 130F+ with eflites motor. Solid motor at a respectable price!

Overall a cheap build motor. The 2 stickers on it flew off on one of the flights. Motor wasnt hot so the stickers werent glued rather attached. The nose cone that came with it is slipping if used with a 10x5 or larger prop. Had to file the shaft to make groves to hold it

this is the fourth one of these I have bought. on three of them I could only find three of the four screws to mount motor to X mount. I did find it stuck and I mean stuck in the prop adapter. after about five to ten min. of pushing it back and forth with an x-acto knife point I was able to get it out . the threads were probably useable but were messed up enough that i used a spare I had as far as the motor after an initial hick-up or two they run great with plenty of power do be aware prop mount hole is 8mm.

Muy buen producto , es de excelente calidad y muy potente , recomendado ampliamente