Renogy 200W 12V Monocrystalline Solar Panel Kit + 30A PWM Charge Controller | 200W 12V Monocrystalline solar starter kit with 2Pcs 100W panels & 30A PWM controller for RV, Boats, Camper,Off-Grid System

Installed this system on my Toy Hauler RV. It is keeping the two batteries charged very nicely. We can watch a movie at night, and the batteries are fully charged by the next evening. I suspect we could watch a couple of movies, but I haven't done this yet. We use LED light bulbs throughout the RV to reduce consumption. I wish more people would go solar and use their generators less. Solar won't power the microwave or air conditioner, but it powers everything else. Some people complain about the controller, but I think it does fine. The complaint is that it doesn't have a meter to show voltage or current. In my opinion, you only want this in the beginning to see how efficient your system is. The controller has LEDs that show when it is charging and when it is in maintenance charge mode (batteries full). I have an inexpensive volt meter that plugs into the 12 volt outlet. Good enough for me. Do not buy the huge fuse holder and 100A fuses that appear as "Items other people bought with this." The correct fuses are 15A and 30A, and you can use standard automotive fuse holders. There is an inexpensive meter that appears when you purchase this, and I recommend that you fully read the instructions and develop a plan before buying it. This meter can only tell you what is happening at the point of installation. For example, some people install this between the panels and the controller (shows panel output), between the controller and the batteries (shows controller output), or between the batteries and the load (shows what the appliances are actually using from the battery). In my opinion, the last application is the only one I care about on an ongoing basis, and the installation for this application is independent of the solar install. Also, take the time to look up the recommended roof attachment procedures for your type of roof. I have an EPM roof, so I looked at the manufacturer videos for attaching a fan to an EPM roof and used those as a guide. I was surprised to learn that butyl tape is the first line of defense and the self-leveling caulk was the second line of defense. If the roof leaks, dry rot will likely follow, and that can be expensive at best or ruin the RV. Some people commented that the connectors are difficult to separate, but there is an inexpensive tool you can buy at checkout to make this easy. The instructions say to hook up the solar panels last or cover them so they don't produce a charge until after they are connected to the controller. I cut cardboard covers from the shipping box and taped them to the panels. This allowed me to lay out everything before the final attachment.

Very pleased with the quality of the product and installation documentation. The panels and charge controller are simply great quality. From the reviews I read before buying, Renogy stands behind its system and responds to troubleshooting customers - a big plus over competition in my purchase decision. A DIYer, I wired the Wanderer Charge Controller into the bedroom of our travel trailer to have immediate access to the system status (and to keep it dry), plus two ammeters; one to monitor solar charge rate to a battery bank and one to monitor our power draw from the same battery bank. That gives us the ability to see the automated doings of the Wanderer, which is really a superb quality charge controller. The system package came with everything necessary, except in-line fuses, to get hooked up to our battery bank (four deep cycle 12-volt flooded cell marine batteries with about 300 amp hour storage capacity) and to run the power cable leads about 8 feet away from the trailer. I purchased an additional 50 feet of power cable (on Amazon - Unlimited Solar's - Solar PV Cable Set with 2 x 50FT MC4 Wire Exntensions - 10 AWG) to be able to place the panels away from shade we might park the trailer in. The MC4 connectors are what Renogy uses and are compatible with other vendor MC4 extensions. For now we are laying the panels on the ground; I will build an adjustable stand for future camping trips. So far everything works great, panels have been in 7 hours of sun per day on two camping trips and kept us charged up for daily 12-volt use (lights, water pump, an electronic ignition propane fridge with a constant 12 watt/0.8 amp draw, propane furnace ignition and fan, CO2 detector). We have shifted our lights to LED's (lower power draw bulbs), but I expect this setup would keep up with higher incandescent bulb's power draw in camping spots with ideal panel exposure. I also plan to have a 200 watt AC inverter in the mix and expect that will be adequately supplied by the system. We really like camping away from campgrounds, in BLM deserts and National Forests, so this is a great set up for us. I will recommend to friends!

I bought this to use our camping. I already have a quiet generator, but I turn it off in the early evening so I don't bug other campers. With that said, This arrived right on time. Installation was pretty easy. I did not install on my roof, to many trees. I attached longer wiring so I could move the panels around to follow the sun. I installed a permanent connection on the outside of my trailer and made longer cords to attach the panels. and from there I contacted the controller on a cabinet right by my door for easy monitoring. I ran a dedicated circuit for my application. (I'm an electrician) The panels are heavier than expected but still easy enough to move around. The system worked without any problems. I only bought a 20ah lithium battery which worked for a few hours. I m buying a bigger battery. This system is only for running a few small items like a TV and DVD player Note: if you do have a generator you can charge the battery with a regular battery charger if there is no sun. Like up here in the pacific northwest. I have already ordered a 100ah lithium battery and 2 more panels so I can use it for longer and more devices. I would recommend this item to everyone.

Using to power to 12 v pumps via a deep cycle battery on my trailer . So far so good . Keeeos battery charged while using through an entire day

I was a little nervous to get these, being on the less expensive side but I'm happy I got them and if I get another one, I will buy the same thing again. I wished there was a better way to connect them to the roof of my trailer house. The brackets are reasonable for general installation in all locations, but for a trailer house roof, it was hard to have them land on the beams all the time and I ended up having to put a lot of white goop stuff (got at local trailer supply) in them to keep it sealed ok. I have not had any leaks yet, but I'm not so sure they'd stay on the trailer if I got in a crash... :) we'll avoid that one hopefully... Install was a tad nerve wracking when it came to the wiring. I saw people bought fuses and fuse cases with it and got he same thinking I needed them, but I ended up using just what it all came with. It seems to do a good job keeping things charged up and I've run the heater and everything for a while to see how it did. I do not plug in my trailer any more and sold my generator (Honda 2000)... I was glad to get rid of the noise (very nice/quiet generator by the way) and gas smell. I was very surprised how well the panels did in the winter. It kept it charged even thought we had a fair amount of snow. That was interesting. Controller is a bid hard to wire to, feel like you are going to break the tiny screws with those big wires. Seems like a little stronger setup could be worked out there. The controller is kinda a self handler though after you get all that done. Haven't done a thing with it. Just look at the lights. Was relieved when it was over and seemed to work and nothing had smoke coming out of it! haha :) And that it keeps running like a charm (so far). Again, I would / will buy more of this one if I get more. I'd like 3-4 panels on my 30' trailer... its a biggy. I did get all LED lamps in this order as well and replaced my entire lighting. Very happy with that decision also. I'd love to get a tesla power wall and install a bunch of these to keep that charged. Not an environmental nut case, just like to get off the big bills. Not sure if they'd be the best for that though.

I have been using the Renogy 200 Watt Solar starter kit on my 29' 5th Wheel for a couple weeks now and I absolutely love it!. This kit came with everything I needed (except in-line fuses) to recharge the batteries in my RV. Instead of mounting the panels on the roof of my RV, I built a stand for them out of some scrap lumber and set them up on the ground. That way I can turn them every couple hours to track the sun. At my location, I have been averaging 9 hours of direct sun on the panels daily (10 am to 7 pm) during the month of August. I haven't had to start my generator once to recharge my two 6 volt 225 AH Interstate Golf Cart batteries. I typically discharge the batteries by about 50% every day, and have had to run the generator in the past daily to recharge the batteries. NOISY! With this starter kit, I have been able to still discharge the batteries by 50% and recharge them to back to full without having to listen to a generator. What a difference! In the future I plan to add 2 more batteries and 2 more Renogy panels. I'm sold on the Renogy brand. All components in the kit are good quality. I've read some complaints about the included PWM charge controller, but the one I received has worked flawlessly. Some day I plan to upgrade to an MPPT controller, but for now, and for my budget, this starter kit has more than sufficed. I would recommend this starter kit to anyone looking to add solar battery charging to their RV.

This my third Renogy system. This one is hooked up to a 400w ups battery and runs string lights, charges phones, accessories, provides lighting, runs a diesel heater, and a water pump. Still makes 17.5v in the shade.

good

Nice solar kit. Have these installed temporarily for now since the ground is frozen. Using to power lights in the shed. Includes almost everything you need for a basic setup. You need to buy fuses for between the panels and controller and also for between the controller and battery. Panels seem well built and are very sturdy. MC4 connectors make connecting them simple and weather tight. Wire sheathing is brittle when cutting.

ركبتهم على سيارتي جمس يوكن مع بطاريه 200 امبير جل والاداء ممتاز

C'est ma première expérience avec des panneaux solaires et ils fonctionnent bien. Je fais en moyen 1,3 Kwh par jour en ce moment avec un bon soleil. J'ai remplacé le convertisseur du kit qui n'est pas terrible par un convertisseur MPPT beaucoup plus sérieux de chez Victron. Il faut également acheter une batterie à décharge lente pour pouvoir stocker l'électricité produite.

Sehr schnelle Lieferung ( 1 Tag ) und Top Solaranlage mit allem was dazu gehört (außer Batterie ). Einfache Montage für jedermann und super Preis .

取り付けが楽でわない。