Mercers FurnitureTrade Corona Grey Wax Nest of Tables

These tables and lovely and are so easy to fix up.

personally found it a little tricky to put together. mostly the screws seemed too long even with electric screwdriver seemed to struggle so swapped out with other screws. But look great and the wooden tops do not show the dust-Bonus!

I am a diy novice and it was easy enough to assemble these tables. However, the main screws which hold the legs and frame together are poor quality. My advice would be to take them immediately to a diy store and buy identical ones you know are good. I didn't do that and subsequently at least two of the screws rounded off during assembly. fortunately they were far enough in to hold. Also, buy a small pot of wood glue. the pouch included isn't quite enough and with the added screw problem at least you know the wooden dowel pins will hold it together. Once assembled they look lovely.

All other furniture is perfect from here. However, these are awful! The holes for the top table part don't match up, screws too long, the tops aren't even the right size and too small!!

Great looking set a bit fiddely to put together but take your time lay it all out look at it first. Easy enough and I'm 72 years young

Bought to compliment the Mercers bookcase, sideboard and tv unit. 80% to a perfect match. Value for the money that we paid for them.

Lovely when put together but use common sense not the instructions

These came with fewer dowels than stated. Holes for aligning table top will need dowels too, but the instruction manual assumes alignment will just happen without using dowels. Screw heads wider than holes for the narrower (though longer) side used to slide smaller tables under. A poor assembly method when these days, there are mechanisms available that just need one to insert latching part in a hole, then a nut from the other side inserts cleanly into it and only needs turning half a circle to one circle and tightens it. I just made a computer table using that mechanism so easily. This, on the other hand, uses wood screws that you need to tighten manually if you follow their instruction manual because they ask not to use electric screwdriver. I suggest you not to heed that and use it regardless. Also use a drill to widen the two holes in the narrower longer strip of connecting wood so that you can insert the provided screws actually. Looks okay, but not very sturdy. Screw holes for the table top, as stated are too small for one of the sides, but are too big for the other three and the table top material is not great so those screws will go a bit too easily while the screws connecting sides to legs may give you blisters.In 2021, not using better more efficient way of tightening two parts together, to me, is not sufficiently intelligent design.Unless you are masochistic, use electric drill/screwdriver, disregard what they say in their manual.Lastly, on one table, two sides were painted on both aspects, but the paint quality differed between the two aspects. All other sides (wood strips connecting legs) were painted on one side only.Wood finish not great, with pain brush 'hair'/bristles stuck in the painted leg.Overall, slightly below average product in my opinion and I wouldn't buy this again.Any table that would use a mechanism like the computer table that I bought (not from this firm) which used a different fastening mechanism for bringing legs and sides together, I'll buy again without hesitation. Not this.