QM3-2694-000 35mm Photo Holder Assy Negative Film Holder & Cover Guide Compatible with Canon CanoScan 8000F 8400F 8800 8800F 9000 9000F,9000F Mark II

Apparently I never had this negative holder when I bought the Canon scanner back years ago. And I never needed it until I began digitizing my photo "collection" It works great as long as you have the software for the scanner installed and up to date.

Avoid this junk. Canoscan negative holders (both this 35mm and the 120 size) are designed to set into two guides, one on each end, to lie flat on the glass. This product DOESN'T do that - it's bowed in the middle so neither end sits flat! As a result, even the most careful placing of the holder is slightly off. The sensor can't quite pinpoint the area to scan. Either it tries to scan too much or too little. Resetting it manually takes three times as long as automatic sensing - and that's assuming it stayed straight enough and didn't sway so much that it's crooked. Huge disappointment. DO NOT BUY!

It helps keep the negative flat but is frustrating to open and close, several contact points.

I could not see any difference between this and the original. I found myself wondering if this where Canon got theirs.

Very flimsy and crops the film a bit. If you need one and don't care about it just need it cheap then sure. But you get what you pay for.

When I opened the package my initial reaction was this was an excellent match with the original CanoScan film tray. I loaded 35mm film and placed it on my 8800F. It didn't feel as firmly locked into position as the original. I took a close look down the side of the carrier and can see a slight bow in the tray.

I cannot tell the difference between

As others have mentioned, the tray is not flat. It arrived packaged well, but it does not lay flat on the scanner. The issue seems to come from the injection mold. The Canon scanner does not push the tray down, so some scans are not top quality.

Seems to work well, its plastic so be delicate with it and it shouldn't break.

It is good product, however it happens to be warped quite bit. When placed on the scanner glass the alignment tabs do not even touch the alignment slots. Tried to bend it the other way with a minor success. I am disappointed with the quality control!

Material is a little fragile, but it's okay to use it. I ordered 2 times, first one had a shrink on the middle part, not able to make the film flat so I returned it, I got the second one, it had no problem. I am happy with it.

Works ok, but the tab is flush with the face, rather than the back, and the entire thing has a slight warp to it, which means a lot of time the tab hole doesnt hold tight to the peg.