Readytosky RS2205 2300KV Brushless Motor CW/CCW 3-4S RC Motors for FPV Racing Drone FPV Multicopter

These work great! I have used 2 of the four so far and they are nice. Work like they should. 10/10

Great motors. Bought for a budget build to see if it was possible and it was. On 4s they do get pretty hot so be mindful and fly accordingly.

I purchased these motors as replacements for my 1208 2300kv quad motors, and installed them with no other changes (using stock beta flight pids.) They work well enough, but are fairly under powered compared to the 1208s I had been using. Current draw is a fair bit higher, as expected, but downsizing from 2200mah to 1600mah fixes most of the issues (at the trade off of flight time.) 6 batteries in and I've not had any heat buildup issues. If you've got a really light 5" quad, these are decent motors.

Quiet, powerful on 4s. Good motors so far, have about 20 flights on them now.

A reasonably priced 2205 motor set, for the price its not bad. The issues I had are that the leads are very difficult to solder too, I had to use a flux for aluminum to get the leads to properly solder too a mr30 plug. They also don't have prop gripper teeth where the prop mounts so slippage is possible.

Ridiculous how cheap these were. All 4 motors worked. Only thing to watch out for - dont use different screws that are too long to mount into the stator. If you use screws that are too long you could thread them into the phase wires in the motor and that will cause motor funkyness and weird start-ups. I did this once and learned it the hard way. This is true for a lot of outrunner motors though, so this one motor in particular is great for the price.

I ordered a set of four to replace a failed motor on my racing drone (Emax 2204's). These were a perfect replacement and having the bullet connector already in place was a huge plus. Installed in mere minutes. Unfortunately one of the motors was a bit notchy feeling and one sounded odd during run-in (possibly bearing). They were a matched cw/ccw pair, so bad set is my guess. The other two were just fine. Considering the extreme low price of these motors, I knew there might be an issue and was ready to mark it as a lesson learned. What I didn't expect is the quick and friendly handling of the situation. I contacted Readytosky directly per the note in the box, and within a short amount of time received a reply. They were very responsive and helpful, and within a couple of days (due to my delay, not theirs) I had a replacement pair in the mail. The new motors were perfect. Despite the delay in getting the drone back in the air due to a bad pair of motors, I'm giving these five stars due to the excellent seller, and subsequent performance of the new motors. It's easy to praise a no-problem purchase, but what makes the difference is how a seller deals with a problem once the sale is complete. I have no qualms recommending them. And if you for some unlikely reason have an issue, know that it will be resolved. And no - I am not affiliated with or was in anyway compensated for this review (I know it sounds that way - I'd think that if I read it :-)

These are poor quality motors. They cut-out periodically while flying. I’ve tried running them on multiple ESCs, propellers, batteries and aircraft but the problem is persistent on the three that I have used. After replacing the motors with equivalent, but less expensive, motors from other manufacturers, my motor issues are gone.

Leider sind 2 der 4 Motoren defekt und drehen nicht hoch, bzw stottern nur. Somit kann ich keine Angaben zur Funktion sagen, aber da andere ähnliches Beschreiben, scheint es hier massive Qualitätsprobleme zu geben, lieber 20-30€ mehr ausgeben... Im Video zu sehen 1x ein defekter Motor und 1x ein funktionierender.