Ten-HIGH AC110V Glass Laser Tube 40W CO2 700mm Length, 50mm Dia for Laser Engraving and Cutting Machine

Siguiendo los pasos en Internet pude cambiar bien mi antiguo láser. Se ve de buena calidad y aunque era más caro por tener los empalmes hechos lo preferí así para evitar complicaciones y riesgos.

Die erste gelieferte Röhre war leider defekt, mir wurde aber nach kurzem Mailverkehr sehr schnell geholfen und eine Ersatzröhre zugesandt. Diese funktioniert nun einwandfrei. Ich kann sowohl die Röhre, als auch den sehr guten Service empfehlen.

Llego el dia que me dijeron y sin ningun problema muy buen servicio excelente producto

梱包が不安でしたが 中身は大丈夫でした。 今のところ快調です。

My laser was losing power and making a high pitch noise. I sent a video to high ten who advised me the tube will need replacing. I had researched about cheap tubes being advertised at a certain power but were actually lower wattage running at peak power and therefore you get a short life. Also on YouTube a guy shows that if you put a piece of white paper behind the tube and see a gold line where the beam goes that shows it’s a good quality. The tube arrived and I did look for that and yes there is the gold. This comes with wires already connected so needs a connection to the high voltage cable. I bought a cloudray connector to save the soldering. Easy to fit. Just be aware that the capacitor can hold high voltage so that needs to discharge before handling the red wire. I ran distilled water through the tube first and made sure there wasn’t any air bubbles, changed all the mirrors while I was at it and ordered a new lens. Realigned and what a difference. A bright thick pinky purple beam and so much more power. It now cuts with less power and more speed and the high pitch sound has gone.