5" Bolt on Picatinny Rail for Hand Guard and Magpul MOE Hand Guard

This rail connector functions quite well on my standard "M4A1" style grip. I found it to be incredibly stable and have had no play in movement since mounting about 6 months ago. The fit for railed items is perfect and the machine quality looks exceptional.

So, I got it and it fits just fine. Be aware, this is designed primarily for magpul MOE furniture and just so happens to fit m16 carbine length handguards. To put on an m16 guard, you'll need some washers. 1/2 work well and I had some m10 washers laying around that were perfect. It won't line up dead center of the m16 guard either, you'll have to move it closer to the front to get all three holes to line up, but they will. When you tighten it down on the m16 guard, make sure it's not canted by manually holding it as you tighten the bolts. It only takes a minute or two and comes out rock solid. Make sure you locktight the screws too. Screws of this size tend to work loose over long periods of time. If you need a nice, affordable option compared to entire modern handguards, this is for you. Very easy to install, and very lightweight but sturdy.

Perfect for what it is

Rail fits excellent on S&W MP-15 handguards..the nuts are too small for the holes on some handguards....a 3/16 aluminum pop rivet washer fixes this issue rather well....and available at any hardware store

As advertised. The hole spacing is minimum 2” apart which was what I needed for my aluminum chassis forearm with pre drilled 10/32 threaded holes.

Had high hopes when I received the rail...it's sturdy, looked properly machined, and it was at the right price. However, the hardware does not completely latch to the inside of the handguard, and the piece only fit if you used 2 of the 3 mounting holes. Could easily be modified, but not worth the time and money. Just spend more for a higher quality product.

Fits my Delton Mod 2 Sport AR-15 perfectly. Installed on the lower M4 type handguard so I could attach a tac light, ez pz. Nice rail at a very good price, includes 3 sets of screws & nuts. Make sure you remove the heat shield before installing, after installing you can put the heat shield back in. Watch a YouTube video if you need to.

This is a very basic product, only having to meet some dimensional requirements and the ability to hook it onto an M4-style forward handguard. It is adequate at that. First, though, it comes in nothing more than a plastic bag. That's it. The rail and an allen wrench in a long, small zipped plastic bag. There were no instructions. There wasn't even a card or label to identify the manufacturer or seller. Second, the washer/nut pieces are just big enough to go through the holes on a M4-style forward handguard. Which means you can't really use the middle one (it's not slotted, so you can't run it up against the side of the handguard hole) to secure the rail. And the other two don't have large enough flanges to lock onto the edges of the holes. I ended up cutting up a washer I had to hold the middle nut in place, and it's now very secure. Once I got it securely in place it works very nicely. It doesn't dig into the palm/fingers, and a couple of different attachments I tried fit right onto it with no difficulty. It would be better with larger flanges on the nuts, and an instruction card that tells you to remove the handguard to install it (since the flanges would no longer fit through the holes). But, since I know what I'm doing, I would order it again, if needed.